321 Stabilized Stainless Cold Sheet 0.95 mm
Titanium-stabilized 321 austenitic stainless cold-rolled sheet, 0.95 mm x 1000 mm wide, no further working applied. Classifies under 7219.34.00 as standard cold-rolled stainless flat-rolled product.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If universal mill plate per note (b)
Plate products meeting width/thickness/pattern criteria have distinct universal mill classification.
If heat-resisting steel per note (g)
Low-carbon Cr steels 4-10.5% classify as heat-resisting under 7220.
If pre-shaped for heat exchanger plates
Parts of heat exchange machinery classify under Chapter 84 functional end-use.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Document stabilization elements (titanium); check for heat-tint from annealing (not further working); use FDA-compliant packing for food contact potential
Related Products under HTS 7219.34.00
410 Martensitic Stainless Cold-Rolled Sheet 0.65 mm
Hardenable 410 martensitic stainless steel cold-rolled to 0.65 mm thickness, over 600 mm wide, mill surface only. HTS 7219.34.00 for cold-reduced stainless not further worked in this gauge range.
Type 304 Cold-Rolled Stainless Steel Sheet 0.8 mm Thick
Flat-rolled stainless steel sheet made from AISI Type 304 alloy, cold-rolled to a precise thickness of 0.8 mm and width exceeding 600 mm, not further worked beyond cold reduction. This product falls under HTS 7219.34.00 due to its stainless steel composition, cold-rolled state without additional surface treatments like polishing or coating, and thickness between 0.5 mm and 1 mm.
430 Grade Cold-Reduced Stainless Steel Coil 0.7 mm
Cold-rolled coil of 430 ferritic stainless steel, 0.7 mm thick and over 600 mm wide, supplied in annealed and pickled condition without further surface treatments. Classified under 7219.34.00 as flat-rolled stainless steel, cold-rolled, within the specified thickness range, and not further worked.
316L Stainless Steel Cold-Rolled Sheet 0.9 mm for Appliances
Low-carbon 316L austenitic stainless steel sheet, cold-rolled to 0.9 mm thickness and 1200 mm width, not further worked, ideal for appliance panels. Meets HTS 7219.34.00 as stainless steel flat-rolled product, cold-reduced, 0.5-1 mm thick, over 600 mm wide.
409 Stainless Steel Cold-Rolled Automotive Trim Sheet 0.6 mm
Ferritic 409 grade stainless steel cold-rolled sheet at 0.6 mm thickness, 1000 mm wide, without further working, used for vehicle trim. Falls under 7219.34.00 for its cold-rolled stainless steel characteristics within the exact thickness and width parameters.
Type 304 Cold-Rolled Stainless Steel Sheet 1 mm Max
Precision cold-rolled Type 304 stainless sheet exactly 1 mm thick, 1500 mm wide coils, not further worked beyond reduction. HTS 7219.34.00 applies to this stainless flat-rolled product due to cold-rolled finish, thickness limit, and lack of additional treatments.