Containing more than 1.5 percent but less than 5 percent by weight of molybdenum
Flat-rolled products of stainless steel, of a width of 600 mm or more: > Not further worked than cold-rolled (cold-reduced): > Of a thickness of 0.5 mm or more but not exceeding 1 mm > In coils: > Other: > Containing more than 0.5 percent by weight of nickel: > Containing more than 1.5 percent but less than 5 percent by weight of molybdenum
Duty Rate (from China)
Except for products described in headings 9903.03.02–9903.03.11, articles the product of any country, as provided for in subdivision (aa) of U.S. note 2 to this subchapter
Effective with respect to entries on or after September 27, 2024, articles the product of China, as provided for in subdivision (b) of U.S. note 31 to this subchapter
Products classified under HTS 7219.34.00.20
Type 316L Cold-Rolled Stainless Steel Coil
Cold-rolled stainless steel coil of 0.8 mm thickness and 1,200 mm width, containing 2.2% molybdenum and 10.5% nickel by weight. Classified under HTS 7219.34.0020 as flat-rolled stainless steel not further worked than cold-rolled, in coils, with thickness 0.5-1 mm, and specific Ni and Mo content per chapter 72 definitions. Used primarily for marine and chemical processing equipment.
17-4PH Precipitation Hardening Stainless Steel Coil
Cold-reduced coil of 17-4PH stainless steel, 0.7 mm thick, 1,000 mm wide, with 3.0% molybdenum and 4.0% nickel. Fits HTS 7219.34.0020 due to cold-rolled state, coil form, precise thickness, and alloy composition exceeding Ni threshold but within Mo range. Common in aerospace fasteners and shafts.
AL-6XN Alloy Cold-Rolled Stainless Steel Coil
0.9 mm thick cold-rolled coil of AL-6XN super-austenitic stainless steel, 1,500 mm width, featuring 2.5% molybdenum and 20% nickel. Matches HTS 7219.34.0020 for wide, thin cold-rolled stainless coils with specified alloying elements. Applied in severe corrosive environments like desalination plants.
Custom 317LMN Stainless Steel Cold Coil
Cold-rolled 317LMN stainless coil, 0.6 mm gauge, 900 mm wide, with 2.8% molybdenum and 13.5% nickel. Precisely classified in HTS 7219.34.0020 for its cold-reduced state, dimensions, and alloy per US notes. Used for pharmaceutical and flue gas desulfurization equipment.
Type 904L Cold-Reduced Stainless Steel Coil
904L austenitic stainless steel cold-rolled in coils, 0.75 mm thick, 1,100 mm width, containing 4.0% molybdenum and 25% nickel. HTS 7219.34.0020 applies for cold-rolled, wide, thin coils with Mo 1.5-5% and Ni >0.5%. Suited for luxury watch cases and chemical tanks.