AL-6XN Alloy Cold-Rolled Stainless Steel Coil
0.9 mm thick cold-rolled coil of AL-6XN super-austenitic stainless steel, 1,500 mm width, featuring 2.5% molybdenum and 20% nickel. Matches HTS 7219.34.0020 for wide, thin cold-rolled stainless coils with specified alloying elements. Applied in severe corrosive environments like desalination plants.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If not in coils but sheets/plates
Coil-specific subheading; non-coiled flat products use adjacent 'other' categories.
If of thickness over 1 mm
Thicker cold-rolled stainless shifts to 7219.22 for >1 mm up to 4.75 mm.
If imported as tubes made from this steel
Fabricated into tubes, moves from flat-rolled Chapter 72 to tubes/pipes in 7304.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Label with precise HTS and alloy grade; mismatches lead to audits
• Confirm cold-rolling only—no artificial oxidation or phosphatizing per Chapter 72 further-worked note
Related Products under HTS 7219.34.00.20
Type 316L Cold-Rolled Stainless Steel Coil
Cold-rolled stainless steel coil of 0.8 mm thickness and 1,200 mm width, containing 2.2% molybdenum and 10.5% nickel by weight. Classified under HTS 7219.34.0020 as flat-rolled stainless steel not further worked than cold-rolled, in coils, with thickness 0.5-1 mm, and specific Ni and Mo content per chapter 72 definitions. Used primarily for marine and chemical processing equipment.
17-4PH Precipitation Hardening Stainless Steel Coil
Cold-reduced coil of 17-4PH stainless steel, 0.7 mm thick, 1,000 mm wide, with 3.0% molybdenum and 4.0% nickel. Fits HTS 7219.34.0020 due to cold-rolled state, coil form, precise thickness, and alloy composition exceeding Ni threshold but within Mo range. Common in aerospace fasteners and shafts.
Custom 317LMN Stainless Steel Cold Coil
Cold-rolled 317LMN stainless coil, 0.6 mm gauge, 900 mm wide, with 2.8% molybdenum and 13.5% nickel. Precisely classified in HTS 7219.34.0020 for its cold-reduced state, dimensions, and alloy per US notes. Used for pharmaceutical and flue gas desulfurization equipment.
Type 904L Cold-Reduced Stainless Steel Coil
904L austenitic stainless steel cold-rolled in coils, 0.75 mm thick, 1,100 mm width, containing 4.0% molybdenum and 25% nickel. HTS 7219.34.0020 applies for cold-rolled, wide, thin coils with Mo 1.5-5% and Ni >0.5%. Suited for luxury watch cases and chemical tanks.