C90500 Yellow Brass Thick Strip
A thick strip of C90500 yellow brass, over 5 mm thick, used for hardware. It falls under tariff item 7409.29.00 as a copper-zinc base alloy (brass) plate, with zinc as the predominant alloying element.
Import Duty Rates by Country of Origin
| Origin Country | MFN Tariff | Surtaxes | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | Free | — | Free |
| 🇲🇽Mexico | Free | — | Free |
| 🇺🇸United States | Free | — | Free |
| 🇩🇪Germany | Free | — | Free |
| 🇯🇵Japan | Free | — | Free |
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If the strip is in coil form
Coiled brass strip is classified under a different subheading.
If the alloy is not a copper-zinc base
Other copper alloys are classified under this residual subheading.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right tariff item — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Ensure the product is in flat strip form and not coiled, as coiled strip is classified differently
• Provide alloy documentation confirming brass composition
• Verify the thickness exceeds 0.15 mm
Related Products under Tariff item 7409.29.00
Admiralty Brass C44300 Plate 5mm+
Admiralty brass plate, 5 mm or more thick, made from copper-zinc-tin alloy (C44300), used for heat exchangers. It qualifies as a brass plate exceeding 0.15 mm in thickness, with tin content below 3%.
Architectural Brass Flat Sheet 2mm
Flat brass sheet, 2 mm thick, made from a copper-zinc base alloy (brass). It is used for architectural applications such as building facades, elevator panels, and interior trim, and qualifies as a plate or sheet of brass exceeding 0.15 mm in thickness.
Architectural Brass Sheet 0.6mm
Architectural brass sheet, 0.6 mm thick and 420 mm wide, is a polished copper-zinc alloy flat product cut to size for door kicks, trim fabrication, and decorative applications. Its width is under 500 mm, but it still qualifies as a sheet under the definition in section note 9. As a brass sheet exceeding 0.15 mm thickness, it is classified under tariff item 7409.29.00.
Brass Artisan Craft Sheet 0.9mm
Brass sheet, 0.9 mm thick, made from a copper-zinc base alloy, intended for use by metal artists, sculptors, and custom fabricators. It meets the definition of a plate or sheet of brass exceeding 0.15 mm in thickness.
Brass Decorative Sheet 0.5mm Thick
Decorative brass sheet, 0.5 mm thick, made from a copper-zinc base alloy, used for decorative panels and architectural trim. It qualifies as a brass plate or sheet exceeding 0.15 mm in thickness.
Brass Electrical Panel Sheet 1.5mm
Brass sheet, 1.5 mm thick, made from a copper-zinc base alloy, used for electrical enclosures and distribution boxes. It falls under this tariff item as a general brass plate or sheet exceeding 0.15 mm in thickness.