Brass Instrument Dial Sheet 0.25mm
0.25mm brass sheet for manufacturing watch/clock dials and gauge faces. HTS 7409.29.00 for copper-zinc base alloy plate just exceeding 0.15mm minimum.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If made into watch dials
Fabricated brass watch dials classified under Chapter 91 watch parts.
If for instrument components
Precision instrument parts shift to Chapter 90.
If powdered form
Powdered brass for sintering classified earlier in Chapter 74.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right HTS code — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Precision instrument sheets require flatness specs in documentation
• Polished surface finish may trigger 7410 classification review
• Small diameter circles risk 'article' vs 'sheet' determination
Related Products under HTS 7409.29.00
Brass Decorative Sheet 0.5mm Thick
A 0.5mm thick brass sheet made from copper-zinc base alloy, used for decorative panels and architectural trim. It falls under HTS 7409.29.00 as a copper-zinc base alloy plate/sheet exceeding 0.15mm thickness, not further worked than specified elsewhere. The zinc content predominates over other elements per subheading note (a).
Brass Nameplate Blanks 0.8mm
Unfinished 0.8mm thick brass blanks for manufacturing nameplates and identification tags. Classified under HTS 7409.29.00 as 'other' brass plates exceeding 0.15mm, meeting copper-zinc alloy criteria without exceeding permitted trace elements.
Brass Gasket Sheet 1.2mm Thick
1.2mm thick brass sheet stock for cutting industrial gaskets and shims. HTS 7409.29.00 applies to this copper-zinc base alloy plate as 'other' form exceeding 0.15mm thickness.
Architectural Brass Flat Sheet 2mm
2mm thick flat brass sheet for building facades, elevator panels, and interior trim. Falls under HTS 7409.29.00 as copper-zinc base alloy plate/sheet >0.15mm, not refined copper or special alloys.
Brass Electrical Panel Sheet 1.5mm
1.5mm brass sheet for electrical enclosures and distribution boxes, copper-zinc alloy. Under HTS 7409.29.00 as general brass plate not specified for special electrical use.
Brass Furniture Inlay Sheet 0.6mm
0.6mm thin brass sheet for furniture veneer inlays and decorative banding. Classified HTS 7409.29.00 as copper-zinc base alloy plate >0.15mm thickness, 'other' category.