Brass Nameplate Blanks 0.8mm
Unfinished 0.8mm thick brass blanks for manufacturing nameplates and identification tags. Classified under HTS 7409.29.00 as 'other' brass plates exceeding 0.15mm, meeting copper-zinc alloy criteria without exceeding permitted trace elements.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If thickness ≤0.15mm
Thinner brass sheets/bars fall under Chapter 74 heading 7407 for profiles/bars/plates ≤0.15mm.
If of copper-nickel-zinc (nickel silver)
Alloys with ≥5% nickel content are classified as nickel silvers under separate subheading per note (c).
If further manufactured into finished nameplates
Completed brass articles not specified elsewhere go to basket provision 7419.99.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide chemical analysis confirming brass composition; US Customs may test for nickel/silver content
• Avoid pre-cut shapes that could be seen as 'articles' under 7419/7420
• Use correct thickness measurement method per HTS notes to prevent misclassification
Related Products under HTS 7409.29.00
Brass Decorative Sheet 0.5mm Thick
A 0.5mm thick brass sheet made from copper-zinc base alloy, used for decorative panels and architectural trim. It falls under HTS 7409.29.00 as a copper-zinc base alloy plate/sheet exceeding 0.15mm thickness, not further worked than specified elsewhere. The zinc content predominates over other elements per subheading note (a).
Brass Gasket Sheet 1.2mm Thick
1.2mm thick brass sheet stock for cutting industrial gaskets and shims. HTS 7409.29.00 applies to this copper-zinc base alloy plate as 'other' form exceeding 0.15mm thickness.
Architectural Brass Flat Sheet 2mm
2mm thick flat brass sheet for building facades, elevator panels, and interior trim. Falls under HTS 7409.29.00 as copper-zinc base alloy plate/sheet >0.15mm, not refined copper or special alloys.
Brass Electrical Panel Sheet 1.5mm
1.5mm brass sheet for electrical enclosures and distribution boxes, copper-zinc alloy. Under HTS 7409.29.00 as general brass plate not specified for special electrical use.
Brass Furniture Inlay Sheet 0.6mm
0.6mm thin brass sheet for furniture veneer inlays and decorative banding. Classified HTS 7409.29.00 as copper-zinc base alloy plate >0.15mm thickness, 'other' category.
Brass Model Making Sheet 0.4mm
0.4mm brass sheet for scale model construction, architectural models, and hobby use. HTS 7409.29.00 applies to this copper-zinc plate exceeding 0.15mm.