Brass HVAC Shim Sheet 0.7mm
0.7mm brass sheet for HVAC ductwork shimming and vibration isolation. HTS 7409.29.00 copper-zinc plate exceeding thickness minimum.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If made into tubing
Brass HVAC tubing classified under 7412 copper tube fittings.
If parts of HVAC machinery
Fabricated HVAC brass parts go to Chapter 84.
If for duct connectors
Brass duct fittings classified iron/steel structures Chapter 73.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• HVAC suppliers need NSF/ANSI certification for some applications
• Coiled sheet common; ensure proper width for plate vs strip
• Oil canning prevention specs important for flatness claims
Related Products under HTS 7409.29.00
Brass Decorative Sheet 0.5mm Thick
A 0.5mm thick brass sheet made from copper-zinc base alloy, used for decorative panels and architectural trim. It falls under HTS 7409.29.00 as a copper-zinc base alloy plate/sheet exceeding 0.15mm thickness, not further worked than specified elsewhere. The zinc content predominates over other elements per subheading note (a).
Brass Nameplate Blanks 0.8mm
Unfinished 0.8mm thick brass blanks for manufacturing nameplates and identification tags. Classified under HTS 7409.29.00 as 'other' brass plates exceeding 0.15mm, meeting copper-zinc alloy criteria without exceeding permitted trace elements.
Brass Gasket Sheet 1.2mm Thick
1.2mm thick brass sheet stock for cutting industrial gaskets and shims. HTS 7409.29.00 applies to this copper-zinc base alloy plate as 'other' form exceeding 0.15mm thickness.
Architectural Brass Flat Sheet 2mm
2mm thick flat brass sheet for building facades, elevator panels, and interior trim. Falls under HTS 7409.29.00 as copper-zinc base alloy plate/sheet >0.15mm, not refined copper or special alloys.
Brass Electrical Panel Sheet 1.5mm
1.5mm brass sheet for electrical enclosures and distribution boxes, copper-zinc alloy. Under HTS 7409.29.00 as general brass plate not specified for special electrical use.
Brass Furniture Inlay Sheet 0.6mm
0.6mm thin brass sheet for furniture veneer inlays and decorative banding. Classified HTS 7409.29.00 as copper-zinc base alloy plate >0.15mm thickness, 'other' category.