D2 Tool Steel Hot-Rolled Coil
Hot-rolled coil of D2 tool steel (1.5% C, 12% Cr), 6 mm thick and 1500 mm wide, used for making shear blades and punches. Classified under HTS 7225.30.11.80 as flat-rolled alloy tool steel, not further worked than hot-rolled, in coils, thickness over 4.75 mm, other than specific described types. Meets tool steel definition with >1.2% C and >10.5% Cr per chapter note (e).
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If further worked with polishing or coating
Chapter note defines 'further worked' to include polishing or metal coating, moving to 'other alloy steel, not in coils' subheading.
If thickness under 4.75 mm
Thinner hot-rolled tool steel coils fall into separate thickness category within same heading.
If not qualifying as tool steel alloy
Lacks specific tool steel composition (e.g., insufficient Cr/C content), classified as standard hot-rolled alloy steel sheet/coil.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide mill test certificate confirming tool steel composition per chapter note (e) to avoid reclassification
• Ensure thickness ≥4.75 mm and width ≥600 mm measured per HTS specs; common pitfall is edge trimming disqualifying coil status
• Declare exact alloy analysis; US note requires certification for tool steel elements like C and Cr content
Related Products under HTS 7225.30.11.80
A2 Tool Steel Hot-Rolled Coil
Hot-rolled coil of A2 air-hardening tool steel (1% C, 5% Cr), 5.5 mm thick, 1200 mm wide, for forming dies and gauges. Falls under 7225.30.11.80 as other tool steel hot-rolled coils ≥4.75 mm thick, meeting tool steel criteria with ≥0.3% C and 1.25-10.5% Cr.
O1 Tool Steel Hot-Rolled Coil
Hot-rolled O1 oil-hardening tool steel coil (0.9% C, 1% Mn), 8 mm thick, 1800 mm wide, for cutting tools and fixtures. HTS 7225.30.11.80 applies to this other tool steel coil, qualifying via note (e)(iii) with ≥0.85% C and 1-1.8% Mn.
S7 Tool Steel Hot-Rolled Coil
Shock-resistant S7 tool steel hot-rolled coil (0.5% C, 3.5% Mo), 7 mm thick, 1000 mm wide, for punches and shear knives. Classified 7225.30.11.80 as other tool steel per note (e)(v) molybdenum content.
M2 Tool Steel Hot-Rolled Coil
M2 high-speed tool steel coil (0.85% C, 6% W, 5% Mo), 4.8 mm thick, 1400 mm wide, for drill bits and end mills. HTS 7225.30.11.80 for other hot-rolled tool steel coils ≥4.75 mm, via note (e)(vi) tungsten content.
CPM-10V Tool Steel Hot-Rolled Coil
CPM-10V powdered metallurgy tool steel hot-rolled coil (2.45% C, 7.4% V), 10 mm thick, 1600 mm wide, for wear-resistant knives. Under 7225.30.11.80 as other tool steel meeting high Cr/C criteria.