O1 Tool Steel Hot-Rolled Coil
Hot-rolled O1 oil-hardening tool steel coil (0.9% C, 1% Mn), 8 mm thick, 1800 mm wide, for cutting tools and fixtures. HTS 7225.30.11.80 applies to this other tool steel coil, qualifying via note (e)(iii) with ≥0.85% C and 1-1.8% Mn.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If high-strength steel specs met
If yield strength qualifies as high-strength per note (a), moves to separate HSS category.
If clad or coated
Metal coating or cladding constitutes 'further worked' under chapter definition.
If carbon steel, not alloy
Below alloy thresholds (<10% total alloying elements), classifies as flat-rolled carbon steel.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right HTS code — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Document Mn and C content precisely; O1 steel's classification hinges on note (e)(iii) manganese range
• Verify width ≥600 mm—narrower products shift to Chapter 72 strip provisions
• Avoid phosphatizing/phosphatizing treatments pre-entry; counts as 'further worked' per chapter note
Related Products under HTS 7225.30.11.80
D2 Tool Steel Hot-Rolled Coil
Hot-rolled coil of D2 tool steel (1.5% C, 12% Cr), 6 mm thick and 1500 mm wide, used for making shear blades and punches. Classified under HTS 7225.30.11.80 as flat-rolled alloy tool steel, not further worked than hot-rolled, in coils, thickness over 4.75 mm, other than specific described types. Meets tool steel definition with >1.2% C and >10.5% Cr per chapter note (e).
A2 Tool Steel Hot-Rolled Coil
Hot-rolled coil of A2 air-hardening tool steel (1% C, 5% Cr), 5.5 mm thick, 1200 mm wide, for forming dies and gauges. Falls under 7225.30.11.80 as other tool steel hot-rolled coils ≥4.75 mm thick, meeting tool steel criteria with ≥0.3% C and 1.25-10.5% Cr.
S7 Tool Steel Hot-Rolled Coil
Shock-resistant S7 tool steel hot-rolled coil (0.5% C, 3.5% Mo), 7 mm thick, 1000 mm wide, for punches and shear knives. Classified 7225.30.11.80 as other tool steel per note (e)(v) molybdenum content.
M2 Tool Steel Hot-Rolled Coil
M2 high-speed tool steel coil (0.85% C, 6% W, 5% Mo), 4.8 mm thick, 1400 mm wide, for drill bits and end mills. HTS 7225.30.11.80 for other hot-rolled tool steel coils ≥4.75 mm, via note (e)(vi) tungsten content.
CPM-10V Tool Steel Hot-Rolled Coil
CPM-10V powdered metallurgy tool steel hot-rolled coil (2.45% C, 7.4% V), 10 mm thick, 1600 mm wide, for wear-resistant knives. Under 7225.30.11.80 as other tool steel meeting high Cr/C criteria.