Duplex 2205 Stainless Sheet
Duplex stainless sheet with 5.5% nickel and 3% molybdenum, flat-rolled <600 mm wide for oil & gas fittings. Matches HTS 7220.90.0010 criteria: stainless, narrow width, defined Ni/Mo ranges without further working.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If heat-resisting steel per note (g)
Low carbon + 4-10.5% Cr qualifies as heat-resisting, separate subheading despite Mo content.
If electroslag remelted
Special electroslag process for alloy steel flat-rolled <600 mm uses 7212 provisions.
If in bar form >80 mm section
Rolled into thick bars exceeds flat-rolled definition, goes to 7222 other bars.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Mill certificates must specify Mo 1.5-5% by weight
• No reductions for rust/discoloration pre-entry
• Measure width precisely—over 600 mm reclassifies entirely
Related Products under HTS 7220.90.00.10
Custom Mo-Bearing Stainless Foil
Tailored thin stainless foil with 2% nickel, 1.8% molybdenum, <600 mm wide for electronics shielding. Fits HTS 7220.90.0010: flat-rolled stainless steel with required Ni/Mo per statistical breakout.
Hastelloy C-276 Equivalent Sheet
Ni-Cr-Mo stainless sheet ~16% nickel, 4% molybdenum approx., <600 mm wide for chemical reactors. Classed in HTS 7220.90.0010 as flat-rolled stainless meeting Ni/Mo weight percentages.
316Mo Stainless Steel Band
Enhanced 316 stainless band with 12% nickel and 2.5% molybdenum, flat-rolled <600 mm for surgical tools. HTS 7220.90.0010 captures its stainless flat-rolled nature and alloy specs.
17-4PH Stainless Steel Sheet
Precipitation-hardening stainless steel sheet with approximately 4% nickel and 3.5% molybdenum, width under 600 mm, used in aerospace components. Falls under HTS 7220.90.0010 due to its stainless steel composition, flat-rolled form less than 600 mm wide, nickel content between 0.5-24%, and molybdenum 1.5-5%. Not further worked beyond basic rolling.
Custom 904L Stainless Steel Strip
High corrosion-resistant stainless strip with 1-2% nickel and 4% molybdenum, narrow width under 600 mm for chemical processing equipment. Classified in HTS 7220.90.0010 for flat-rolled stainless steel with specified nickel and molybdenum ranges, not in coils or further processed.
Alloy 254 SMO Steel Plate
Super austenitic stainless steel plate with 18% nickel and 2.5% molybdenum, under 600 mm wide for marine applications. HTS 7220.90.0010 applies to its flat-rolled stainless form, mid-range nickel, and precise molybdenum content per U.S. notes.