Custom 904L Stainless Steel Strip
High corrosion-resistant stainless strip with 1-2% nickel and 4% molybdenum, narrow width under 600 mm for chemical processing equipment. Classified in HTS 7220.90.0010 for flat-rolled stainless steel with specified nickel and molybdenum ranges, not in coils or further processed.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If molybdenum 5% or higher
Mo content at or above 5% places it in the residual 'other' subheading within 7220.90, outside this specific molybdenum range.
If not qualifying as stainless steel
If chromium content insufficient for stainless definition, reverts to general alloy flat-rolled steel in 7219.
If supplied in coil form
Coiled flat-rolled products of alloy steel width <600 mm classify under 7225, not straight flat-rolled in 7220.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Certify molybdenum exactly between 1.5-5% via chemical analysis reports at entry
• Confirm flat-rolled status without cladding or enameling per chapter notes
• Avoid common pitfall of mismeasuring width leading to 7221 classification
Related Products under HTS 7220.90.00.10
Custom Mo-Bearing Stainless Foil
Tailored thin stainless foil with 2% nickel, 1.8% molybdenum, <600 mm wide for electronics shielding. Fits HTS 7220.90.0010: flat-rolled stainless steel with required Ni/Mo per statistical breakout.
Hastelloy C-276 Equivalent Sheet
Ni-Cr-Mo stainless sheet ~16% nickel, 4% molybdenum approx., <600 mm wide for chemical reactors. Classed in HTS 7220.90.0010 as flat-rolled stainless meeting Ni/Mo weight percentages.
316Mo Stainless Steel Band
Enhanced 316 stainless band with 12% nickel and 2.5% molybdenum, flat-rolled <600 mm for surgical tools. HTS 7220.90.0010 captures its stainless flat-rolled nature and alloy specs.
17-4PH Stainless Steel Sheet
Precipitation-hardening stainless steel sheet with approximately 4% nickel and 3.5% molybdenum, width under 600 mm, used in aerospace components. Falls under HTS 7220.90.0010 due to its stainless steel composition, flat-rolled form less than 600 mm wide, nickel content between 0.5-24%, and molybdenum 1.5-5%. Not further worked beyond basic rolling.
Alloy 254 SMO Steel Plate
Super austenitic stainless steel plate with 18% nickel and 2.5% molybdenum, under 600 mm wide for marine applications. HTS 7220.90.0010 applies to its flat-rolled stainless form, mid-range nickel, and precise molybdenum content per U.S. notes.
AL-6XN Stainless Steel Foil
Thin flat-rolled stainless foil with 21% nickel and 2.4% molybdenum, width <600 mm for heat exchanger manufacturing. Fits HTS 7220.90.0010 as stainless, flat-rolled under 600 mm with qualifying alloy elements, not further worked.