Pickled Cold-Rolled Steel Blank 1.6mm
Pickled cold-rolled nonalloy steel blanks, 1.6 mm thickness, 750 mm width, cut-to-size sheets. HTS 7209.26.00.00 applies as pickling is permitted pre-cold-rolling treatment, not 'further worked'.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If thickness of 1 mm or less
Same form but thinner sheets have dedicated 7209 subheading.
If corrugated or crimped
Profiled surface constitutes 'further worked' per Chapter notes.
If stainless steel
Stainless variants go to Chapter 72 stainless flat-rolled provisions.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Document pickling as pre-treatment only; measure uncoiled sheet dimensions; beware AD/CVD on certain origins
Related Products under HTS 7209.26.00.00
Cold-Rolled Nonalloy Steel Sheet 1.5mm Thick
Flat-rolled nonalloy steel sheet, cold-rolled, measuring 1.5 mm thick and 1,200 mm wide, supplied in rectangular sheets not in coils. It falls under HTS 7209.26.00.00 as it is not clad, plated, or coated, and not further worked beyond cold-rolling, with thickness between 1 mm and 3 mm.
HRPO Cold-Rolled Steel Sheet 2mm
Hot-rolled pickled and oiled (HRPO) cold-reduced nonalloy steel sheet, 2 mm thick, 1,000 mm wide, in cut-to-length sheets. Classified under 7209.26.00.00 because pickling/oiling does not qualify as 'further worked' per Chapter 72 notes, remaining simply cold-rolled.
Cold-Rolled Mild Steel Panel 1.8mm
Low-carbon mild steel cold-rolled panels, 1.8 mm thickness, 1,500 mm width, supplied flat in sheets for fabrication. Meets HTS 7209.26.00.00 criteria: nonalloy, cold-rolled only, width over 600 mm, thickness 1-3 mm, not coiled or coated.
SPHC Cold-Rolled Steel Sheet 2.5mm
SPHC grade commercial quality cold-rolled nonalloy steel sheet, 2.5 mm thick, 900 mm wide, in discrete sheets. Fits 7209.26.00.00 as cold-reduced flat product, no cladding/coating, width ≥600 mm, proper thickness range.
Cold-Rolled Drawing Steel Sheet 1.2mm
Deep drawing quality (DDQ) cold-rolled nonalloy steel sheet, 1.2 mm thick, 1,250 mm wide, sheet form. Under HTS 7209.26.00.00 for its cold-rolled, uncoated, non-coil status and specified dimensions.
Cold-Rolled Structural Steel Sheet 2.2mm
SS400 grade cold-rolled nonalloy steel sheet for structural use, 2.2 mm thick, 1,800 mm wide sheets. Classifies to 7209.26.00.00: flat-rolled, cold-reduced, no further working, correct width/thickness.