Of a thickness exceeding 1 mm but less than 3 mm
Flat-rolled products of iron or nonalloy steel, of a width of 600 mm or more, cold-rolled (cold-reduced), not clad, plated or coated: > Not in coils, not further worked than cold-rolled (cold-reduced): > Of a thickness exceeding 1 mm but less than 3 mm
Duty Rate (from China)
Except for products described in headings 9903.03.02–9903.03.11, articles the product of any country, as provided for in subdivision (aa) of U.S. note 2 to this subchapter
Effective with respect to entries on or after September 27, 2024, articles the product of China, as provided for in subdivision (b) of U.S. note 31 to this subchapter
Products classified under HTS 7209.26.00.00
Cold-Rolled Nonalloy Steel Sheet 1.5mm Thick
Flat-rolled nonalloy steel sheet, cold-rolled, measuring 1.5 mm thick and 1,200 mm wide, supplied in rectangular sheets not in coils. It falls under HTS 7209.26.00.00 as it is not clad, plated, or coated, and not further worked beyond cold-rolling, with thickness between 1 mm and 3 mm.
HRPO Cold-Rolled Steel Sheet 2mm
Hot-rolled pickled and oiled (HRPO) cold-reduced nonalloy steel sheet, 2 mm thick, 1,000 mm wide, in cut-to-length sheets. Classified under 7209.26.00.00 because pickling/oiling does not qualify as 'further worked' per Chapter 72 notes, remaining simply cold-rolled.
Cold-Rolled Mild Steel Panel 1.8mm
Low-carbon mild steel cold-rolled panels, 1.8 mm thickness, 1,500 mm width, supplied flat in sheets for fabrication. Meets HTS 7209.26.00.00 criteria: nonalloy, cold-rolled only, width over 600 mm, thickness 1-3 mm, not coiled or coated.
SPHC Cold-Rolled Steel Sheet 2.5mm
SPHC grade commercial quality cold-rolled nonalloy steel sheet, 2.5 mm thick, 900 mm wide, in discrete sheets. Fits 7209.26.00.00 as cold-reduced flat product, no cladding/coating, width ≥600 mm, proper thickness range.
Cold-Rolled Drawing Steel Sheet 1.2mm
Deep drawing quality (DDQ) cold-rolled nonalloy steel sheet, 1.2 mm thick, 1,250 mm wide, sheet form. Under HTS 7209.26.00.00 for its cold-rolled, uncoated, non-coil status and specified dimensions.
Cold-Rolled Structural Steel Sheet 2.2mm
SS400 grade cold-rolled nonalloy steel sheet for structural use, 2.2 mm thick, 1,800 mm wide sheets. Classifies to 7209.26.00.00: flat-rolled, cold-reduced, no further working, correct width/thickness.
Pickled Cold-Rolled Steel Blank 1.6mm
Pickled cold-rolled nonalloy steel blanks, 1.6 mm thickness, 750 mm width, cut-to-size sheets. HTS 7209.26.00.00 applies as pickling is permitted pre-cold-rolling treatment, not 'further worked'.
Cold-Rolled Commercial Quality Steel 2.8mm
CQ grade cold-rolled nonalloy steel sheet, 2.8 mm thick, 1,100 mm wide, not in coils. Perfect match for 7209.26.00.00: width 600+ mm, cold-rolled only, no plating/coating.