Cold-Rolled Nonalloy Steel Sheet 1.5mm Thick
Flat-rolled nonalloy steel sheet, cold-rolled, measuring 1.5 mm thick and 1,200 mm wide, supplied in rectangular sheets not in coils. It falls under HTS 7209.26.00.00 as it is not clad, plated, or coated, and not further worked beyond cold-rolling, with thickness between 1 mm and 3 mm.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If thickness of 1 mm or less
Thinner cold-rolled sheets fall under the preceding thickness subheading within the same cold-rolled, not in coils category.
If in coils instead of sheets
Cold-rolled nonalloy steel of similar thickness but supplied in coils is classified under heading 7211, not 7209.
If clad, plated, or coated
Any surface treatment beyond cold-rolling moves the product to Chapter 72 clad/plated headings like 7210.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Verify exact thickness measurement between 1-3 mm with certified mill test reports; ensure product is truly 'not further worked' (no polishing or coating); declare width ≥600 mm accurately to avoid reclassification
Related Products under HTS 7209.26.00.00
HRPO Cold-Rolled Steel Sheet 2mm
Hot-rolled pickled and oiled (HRPO) cold-reduced nonalloy steel sheet, 2 mm thick, 1,000 mm wide, in cut-to-length sheets. Classified under 7209.26.00.00 because pickling/oiling does not qualify as 'further worked' per Chapter 72 notes, remaining simply cold-rolled.
Cold-Rolled Mild Steel Panel 1.8mm
Low-carbon mild steel cold-rolled panels, 1.8 mm thickness, 1,500 mm width, supplied flat in sheets for fabrication. Meets HTS 7209.26.00.00 criteria: nonalloy, cold-rolled only, width over 600 mm, thickness 1-3 mm, not coiled or coated.
SPHC Cold-Rolled Steel Sheet 2.5mm
SPHC grade commercial quality cold-rolled nonalloy steel sheet, 2.5 mm thick, 900 mm wide, in discrete sheets. Fits 7209.26.00.00 as cold-reduced flat product, no cladding/coating, width ≥600 mm, proper thickness range.
Cold-Rolled Drawing Steel Sheet 1.2mm
Deep drawing quality (DDQ) cold-rolled nonalloy steel sheet, 1.2 mm thick, 1,250 mm wide, sheet form. Under HTS 7209.26.00.00 for its cold-rolled, uncoated, non-coil status and specified dimensions.
Cold-Rolled Structural Steel Sheet 2.2mm
SS400 grade cold-rolled nonalloy steel sheet for structural use, 2.2 mm thick, 1,800 mm wide sheets. Classifies to 7209.26.00.00: flat-rolled, cold-reduced, no further working, correct width/thickness.
Pickled Cold-Rolled Steel Blank 1.6mm
Pickled cold-rolled nonalloy steel blanks, 1.6 mm thickness, 750 mm width, cut-to-size sheets. HTS 7209.26.00.00 applies as pickling is permitted pre-cold-rolling treatment, not 'further worked'.