HRPO Cold-Rolled Steel Sheet 2mm
Hot-rolled pickled and oiled (HRPO) cold-reduced nonalloy steel sheet, 2 mm thick, 1,000 mm wide, in cut-to-length sheets. Classified under 7209.26.00.00 because pickling/oiling does not qualify as 'further worked' per Chapter 72 notes, remaining simply cold-rolled.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If hot-rolled, not cold-rolled
Similar thickness hot-rolled sheets (pickled/oiled) remain under 7208, lacking cold-reduction process.
If further worked like painted
Painting or other Chapter 72 'further worked' treatments shift to clad/coated categories in 7212.
If shaped into welded pipes
Post-import fabrication into cylindrical sections for pipes changes classification to tubes/pipes heading.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide chemical composition analysis to confirm nonalloy status (<0.3% certain elements); distinguish HRPO from coated products via surface inspection; watch for Section 232 steel tariffs applicability
Related Products under HTS 7209.26.00.00
Cold-Rolled Nonalloy Steel Sheet 1.5mm Thick
Flat-rolled nonalloy steel sheet, cold-rolled, measuring 1.5 mm thick and 1,200 mm wide, supplied in rectangular sheets not in coils. It falls under HTS 7209.26.00.00 as it is not clad, plated, or coated, and not further worked beyond cold-rolling, with thickness between 1 mm and 3 mm.
Cold-Rolled Mild Steel Panel 1.8mm
Low-carbon mild steel cold-rolled panels, 1.8 mm thickness, 1,500 mm width, supplied flat in sheets for fabrication. Meets HTS 7209.26.00.00 criteria: nonalloy, cold-rolled only, width over 600 mm, thickness 1-3 mm, not coiled or coated.
SPHC Cold-Rolled Steel Sheet 2.5mm
SPHC grade commercial quality cold-rolled nonalloy steel sheet, 2.5 mm thick, 900 mm wide, in discrete sheets. Fits 7209.26.00.00 as cold-reduced flat product, no cladding/coating, width ≥600 mm, proper thickness range.
Cold-Rolled Drawing Steel Sheet 1.2mm
Deep drawing quality (DDQ) cold-rolled nonalloy steel sheet, 1.2 mm thick, 1,250 mm wide, sheet form. Under HTS 7209.26.00.00 for its cold-rolled, uncoated, non-coil status and specified dimensions.
Cold-Rolled Structural Steel Sheet 2.2mm
SS400 grade cold-rolled nonalloy steel sheet for structural use, 2.2 mm thick, 1,800 mm wide sheets. Classifies to 7209.26.00.00: flat-rolled, cold-reduced, no further working, correct width/thickness.
Pickled Cold-Rolled Steel Blank 1.6mm
Pickled cold-rolled nonalloy steel blanks, 1.6 mm thickness, 750 mm width, cut-to-size sheets. HTS 7209.26.00.00 applies as pickling is permitted pre-cold-rolling treatment, not 'further worked'.