3003 Aluminum Sheet 3mm - Wait, Non-Alloy Only
99% pure aluminum sheet 6mm thick for architectural panels, meeting strict non-alloy specs. HTS 7606.91.30.95 applies to this rolled, unclad plate/sheet.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If assembled into panels
Finished composite panels classify as articles of asphalt/stone in 6807.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Certify exact thickness at multiple points to confirm ≤6.3mm
• Distinguish from alloys via spectrometry if mixed lots
Related Products under HTS 7606.91.30.95
1050 Aluminum Sheet 3mm Thick
A rectangular sheet of unalloyed 1050 aluminum with 99.5% purity and thickness of 3mm, used for general fabrication. It falls under HTS 7606.91.30.95 as it is not clad, rectangular, exceeds 0.2mm but not 6.3mm thick, and meets the non-alloyed aluminum definition (Fe+Si ≤0.1%). Ideal for lightweight structural components.
1100 Aluminum Plate 4mm Thick
Unclad 1100 grade aluminum plate, 4mm thick, with high purity for corrosion-resistant applications like chemical tanks. Classified in 7606.91.30.95 due to non-alloyed composition, plate/sheet form, and thickness between 0.2mm and 6.3mm.
1070 Pure Aluminum Sheet 2.5mm
High-purity 1070 aluminum sheet at 2.5mm thickness, used in electronics reflectors. Meets HTS 7606.91.30.95 as rectangular, rolled, unclad, non-alloyed (≥99.7% Al), thickness 0.2-6.3mm.
1060 Aluminum Flat Sheet 5mm Thick
Commercial pure 1060 aluminum flat sheet, 5mm thick for signage and cladding. Under 7606.91.30.95: non-alloyed per note (a), not clad, thickness ≤6.3mm.
1050 H14 Aluminum Sheet 4.5mm
Tempered H14 1050 aluminum sheet 4.5mm thick for trailer skins. Non-alloyed, flat rolled sheet under 7606.91.30.95 thickness spec.
1100 O Temper Sheet 2mm Thick
Annealed O temper 1100 aluminum sheet 2mm for soft forming applications. Pure non-alloyed per definition, ≤6.3mm thick sheet.