1060 Aluminum Flat Sheet 5mm Thick
Commercial pure 1060 aluminum flat sheet, 5mm thick for signage and cladding. Under 7606.91.30.95: non-alloyed per note (a), not clad, thickness ≤6.3mm.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If thickness >6.3mm
Thicker non-alloyed plates >6.3mm fall into next thickness subheading.
If household foil grade
Very thin (<0.2mm) or foil products go to 7607/7608.
If in wire form ≤6mm
Chapter note limits 'wire' in 7616.91 to ≤6mm cross-section.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Include heat number traceability for origin verification
• Watch for thickness tolerance; exceeding 6.3mm shifts to 7606.91.60
• Separate from any alloys in shipment to prevent commingling errors
Related Products under HTS 7606.91.30.95
1050 Aluminum Sheet 3mm Thick
A rectangular sheet of unalloyed 1050 aluminum with 99.5% purity and thickness of 3mm, used for general fabrication. It falls under HTS 7606.91.30.95 as it is not clad, rectangular, exceeds 0.2mm but not 6.3mm thick, and meets the non-alloyed aluminum definition (Fe+Si ≤0.1%). Ideal for lightweight structural components.
1100 Aluminum Plate 4mm Thick
Unclad 1100 grade aluminum plate, 4mm thick, with high purity for corrosion-resistant applications like chemical tanks. Classified in 7606.91.30.95 due to non-alloyed composition, plate/sheet form, and thickness between 0.2mm and 6.3mm.
1070 Pure Aluminum Sheet 2.5mm
High-purity 1070 aluminum sheet at 2.5mm thickness, used in electronics reflectors. Meets HTS 7606.91.30.95 as rectangular, rolled, unclad, non-alloyed (≥99.7% Al), thickness 0.2-6.3mm.
3003 Aluminum Sheet 3mm - Wait, Non-Alloy Only
99% pure aluminum sheet 6mm thick for architectural panels, meeting strict non-alloy specs. HTS 7606.91.30.95 applies to this rolled, unclad plate/sheet.
1050 H14 Aluminum Sheet 4.5mm
Tempered H14 1050 aluminum sheet 4.5mm thick for trailer skins. Non-alloyed, flat rolled sheet under 7606.91.30.95 thickness spec.
1100 O Temper Sheet 2mm Thick
Annealed O temper 1100 aluminum sheet 2mm for soft forming applications. Pure non-alloyed per definition, ≤6.3mm thick sheet.