Cold-Drawn H13 Tool Steel Bar
H13 hot-work tool steel bar cold-drawn to 24 mm round, high chromium/molybdenum content per tool steel definition. Classified HTS 7228.50.10.80 for cold-finished tool steel bars ≥18 mm cross-section, not further worked.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If razor blade steel
Ultra-thin stainless for razors (≤0.25mm, specific Cr) separate.
If welded tubes from bars
Post-import fabrication into tubes changes classification.
If heat-resisting steel
Low-carbon, high-Cr heat-resisting alloys excluded from tool steel.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Ensure documentation specifies 'cold-finished' vs hot-rolled to prevent heading shift
• Comply with AD/CVD orders on certain tool steel origins
Related Products under HTS 7228.50.10.80
Cold-Finished D2 Tool Steel Round Bar
A cold-finished round bar made from D2 tool steel, an alloy steel with high chromium and carbon content meeting tool steel definitions, featuring a diameter of 20 mm. Classified under HTS 7228.50.10.80 as other bars and rods of tool steel (not high-speed), cold-formed or cold-finished, with maximum cross-sectional dimension over 18 mm. Not further worked beyond cold-finishing per chapter notes.
A2 Tool Steel Cold-Drawn Flat Bar
Cold-drawn flat bar of A2 air-hardening tool steel (1% carbon, 5% chromium), 25 mm wide by 10 mm thick, used for dies and gauges. Falls under HTS 7228.50.10.80 for tool steel bars cold-finished with cross-sectional dimension over 18 mm, not further worked. Meets U.S. Note (e)(ii) tool steel criteria.
S7 Tool Steel Cold-Formed Round Bar
S7 shock-resisting tool steel round bar, cold-formed to 19 mm diameter, for impact tools. Under HTS 7228.50.10.80 as other tool steel bars (meeting carbon/chromium specs), cold-finished, ≥18 mm cross-section, without further surface treatments.
M2 Tool Steel Cold-Finished Hex Bar
Cold-finished hexagonal bar of M2 tool steel (meets general tool steel note via C/Cr), 21 mm across flats, for cutting tools. HTS 7228.50.10.80 covers such other tool steel bars cold-formed with max dimension over 18 mm.
L6 Tool Steel Cold-Formed Flat Stock
L6 nickel-improved tool steel cold-formed flat, 30 mm x 15 mm, for structural tools. HTS 7228.50.10.80 as tool steel (alloy per note e) cold-finished bar >18 mm dimension.
Cold-Finished CPM-M4 Tool Steel Round
CPM-M4 powder metallurgy tool steel round bar, cold-finished 25 mm diameter, high wear resistance. Under 7228.50.10.80 for other tool steel cold-formed bars ≥18 mm.