Other
Other bars and rods of other alloy steel; angles, shapes and sections, of other alloy steel; hollow drill bars and rods, of alloy or nonalloy steel: > Other bars and rods, not further worked than cold-formed or cold-finished: > Of tool steel (other than high-speed steel) > Other: > With a maximum cross-sectional dimension of 18 mm or more: > Other
Duty Rate (from China)
Except for products described in headings 9903.03.02–9903.03.11, articles the product of any country, as provided for in subdivision (aa) of U.S. note 2 to this subchapter
Effective with respect to entries on or after September 27, 2024, articles the product of China, as provided for in subdivision (b) of U.S. note 31 to this subchapter
Products classified under HTS 7228.50.10.80
Cold-Finished D2 Tool Steel Round Bar
A cold-finished round bar made from D2 tool steel, an alloy steel with high chromium and carbon content meeting tool steel definitions, featuring a diameter of 20 mm. Classified under HTS 7228.50.10.80 as other bars and rods of tool steel (not high-speed), cold-formed or cold-finished, with maximum cross-sectional dimension over 18 mm. Not further worked beyond cold-finishing per chapter notes.
A2 Tool Steel Cold-Drawn Flat Bar
Cold-drawn flat bar of A2 air-hardening tool steel (1% carbon, 5% chromium), 25 mm wide by 10 mm thick, used for dies and gauges. Falls under HTS 7228.50.10.80 for tool steel bars cold-finished with cross-sectional dimension over 18 mm, not further worked. Meets U.S. Note (e)(ii) tool steel criteria.
S7 Tool Steel Cold-Formed Round Bar
S7 shock-resisting tool steel round bar, cold-formed to 19 mm diameter, for impact tools. Under HTS 7228.50.10.80 as other tool steel bars (meeting carbon/chromium specs), cold-finished, ≥18 mm cross-section, without further surface treatments.
M2 Tool Steel Cold-Finished Hex Bar
Cold-finished hexagonal bar of M2 tool steel (meets general tool steel note via C/Cr), 21 mm across flats, for cutting tools. HTS 7228.50.10.80 covers such other tool steel bars cold-formed with max dimension over 18 mm.
L6 Tool Steel Cold-Formed Flat Stock
L6 nickel-improved tool steel cold-formed flat, 30 mm x 15 mm, for structural tools. HTS 7228.50.10.80 as tool steel (alloy per note e) cold-finished bar >18 mm dimension.
Cold-Finished CPM-M4 Tool Steel Round
CPM-M4 powder metallurgy tool steel round bar, cold-finished 25 mm diameter, high wear resistance. Under 7228.50.10.80 for other tool steel cold-formed bars ≥18 mm.
O1 Cold-Finished Tool Steel Square Bar
O1 oil-hardening tool steel square bar, cold-finished to 22 mm x 22 mm, for tool making and fixtures. HTS 7228.50.10.80 applies to such tool steel (U.S. Note e(iii): ≥0.85% C, 1-1.8% Mn) bars cold-formed, max dimension ≥18 mm, not further worked.
Cold-Drawn H13 Tool Steel Bar
H13 hot-work tool steel bar cold-drawn to 24 mm round, high chromium/molybdenum content per tool steel definition. Classified HTS 7228.50.10.80 for cold-finished tool steel bars ≥18 mm cross-section, not further worked.