Hot-Rolled H13 Tool Steel Plate 280mm Wide
H13 hot work tool steel flat plate, hot-rolled only, 280mm x 5mm, for die casting molds. HTS 7226.91.25 for tool steel <300mm wide, not further worked.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If further worked angles/shapes
Tool steel further worked into angles uses 7228.70.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• H13 cert must confirm note (e)(ii) 1.25-10.5% Cr
• No varnishing/painting allowed
Related Products under HTS 7226.91.25
Hot-Rolled W1 Tool Steel Sheet 160mm Wide
W1 water-hardening tool steel.
Hot-Rolled F2 Tool Steel Strip 270mm Wide
F2 chipper knife candidate, but general tool.
Hot-Rolled D2 Tool Steel Sheet 200mm Wide
Flat-rolled D2 tool steel sheet, hot-rolled with no further surface treatment, measuring 200mm in width and 3mm thick. Classified under HTS 7226.91.25 as alloy tool steel (over 1.2% carbon and over 10.5% chromium per note (e)(i)) not further worked than hot-rolled, width under 300mm. Used primarily for making punches, dies, and shear blades.
Hot-Rolled A2 Tool Steel Strip 150mm Wide
Hot-rolled A2 air-hardening tool steel strip, 150mm wide by 2.5mm thick, without further working like polishing or coating. Fits HTS 7226.91.25 as other tool steel (0.3-1.2% C with 1.25-10.5% Cr per note (e)(ii)), width <300mm. Ideal for forming dies and gauges.
Hot-Rolled O1 Tool Steel Plate 250mm Wide
O1 oil-hardening tool steel flat-rolled plate, hot-rolled only, 250mm width and 4mm thickness. Under HTS 7226.91.25 for tool steel (0.85%+ C, 1-1.8% Mn per note (e)(iii)), <300mm wide, not further worked. Commonly used for cutting tools and fixtures.
Hot-Rolled CPM-M4 Tool Steel Sheet 180mm Wide
Particle metallurgy CPM-M4 high-vanadium tool steel sheet, hot-rolled, 180mm wide x 2mm thick, no further processing. HTS 7226.91.25 applies to this other tool steel (<300mm wide), used for wear-resistant dies and inserts.