Hot-Rolled CPM-M4 Tool Steel Sheet 180mm Wide
Particle metallurgy CPM-M4 high-vanadium tool steel sheet, hot-rolled, 180mm wide x 2mm thick, no further processing. HTS 7226.91.25 applies to this other tool steel (<300mm wide), used for wear-resistant dies and inserts.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If qualifies as high-speed steel
M4 composition (high Mo/W/V) typically meets high-speed steel criteria, classifying under 7226.91.15.
If width >=600mm
Wider hot-rolled tool steel falls under broader width category 7225.30.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right HTS code — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Certify meets tool steel via carbon/chromium or other note (e) combinations; PM process doesn't affect classification
• Confirm mill scale present, indicating hot-rolled not further worked state
• Beware of partial rust—no duty reduction allowed per chapter note
Related Products under HTS 7226.91.25
Hot-Rolled W1 Tool Steel Sheet 160mm Wide
W1 water-hardening tool steel.
Hot-Rolled F2 Tool Steel Strip 270mm Wide
F2 chipper knife candidate, but general tool.
Hot-Rolled D2 Tool Steel Sheet 200mm Wide
Flat-rolled D2 tool steel sheet, hot-rolled with no further surface treatment, measuring 200mm in width and 3mm thick. Classified under HTS 7226.91.25 as alloy tool steel (over 1.2% carbon and over 10.5% chromium per note (e)(i)) not further worked than hot-rolled, width under 300mm. Used primarily for making punches, dies, and shear blades.
Hot-Rolled A2 Tool Steel Strip 150mm Wide
Hot-rolled A2 air-hardening tool steel strip, 150mm wide by 2.5mm thick, without further working like polishing or coating. Fits HTS 7226.91.25 as other tool steel (0.3-1.2% C with 1.25-10.5% Cr per note (e)(ii)), width <300mm. Ideal for forming dies and gauges.
Hot-Rolled O1 Tool Steel Plate 250mm Wide
O1 oil-hardening tool steel flat-rolled plate, hot-rolled only, 250mm width and 4mm thickness. Under HTS 7226.91.25 for tool steel (0.85%+ C, 1-1.8% Mn per note (e)(iii)), <300mm wide, not further worked. Commonly used for cutting tools and fixtures.
Hot-Rolled S7 Tool Steel Strip 120mm Wide
S7 shock-resisting tool steel hot-rolled strip, 120mm width, 3.5mm thick, untreated beyond hot-rolling. Classed in 7226.91.25 as tool steel alloy (<300mm wide), suited for punches and shear knives.