Hot-Rolled D2 Tool Steel Sheet 200mm Wide
Flat-rolled D2 tool steel sheet, hot-rolled with no further surface treatment, measuring 200mm in width and 3mm thick. Classified under HTS 7226.91.25 as alloy tool steel (over 1.2% carbon and over 10.5% chromium per note (e)(i)) not further worked than hot-rolled, width under 300mm. Used primarily for making punches, dies, and shear blades.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If high-speed steel composition
High-speed tool steels (with tungsten/molybdenum/vanadium exceeding specific thresholds) classify under 7226.91.15, separate from other tool steel.
If width 600mm or more
Same hot-rolled tool steel but wider dimension shifts to 7225 heading for flat-rolled alloy steel >=600mm.
If cold-rolled instead of hot-rolled
Cold-rolled tool steel flat products fall under 7226.92, as 'further worked' beyond hot-rolling.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide mill test certificate confirming tool steel composition meets US note (e) criteria (e.g
• >1.2% C, >10.5% Cr for D2)
• Declare exact width (<300mm) and confirm not further worked than hot-rolled; no polishing or coating allowed
• Avoid common pitfall of rust/discoloration claims—no duty allowance per chapter note
Related Products under HTS 7226.91.25
Hot-Rolled W1 Tool Steel Sheet 160mm Wide
W1 water-hardening tool steel.
Hot-Rolled F2 Tool Steel Strip 270mm Wide
F2 chipper knife candidate, but general tool.
Hot-Rolled A2 Tool Steel Strip 150mm Wide
Hot-rolled A2 air-hardening tool steel strip, 150mm wide by 2.5mm thick, without further working like polishing or coating. Fits HTS 7226.91.25 as other tool steel (0.3-1.2% C with 1.25-10.5% Cr per note (e)(ii)), width <300mm. Ideal for forming dies and gauges.
Hot-Rolled O1 Tool Steel Plate 250mm Wide
O1 oil-hardening tool steel flat-rolled plate, hot-rolled only, 250mm width and 4mm thickness. Under HTS 7226.91.25 for tool steel (0.85%+ C, 1-1.8% Mn per note (e)(iii)), <300mm wide, not further worked. Commonly used for cutting tools and fixtures.
Hot-Rolled CPM-M4 Tool Steel Sheet 180mm Wide
Particle metallurgy CPM-M4 high-vanadium tool steel sheet, hot-rolled, 180mm wide x 2mm thick, no further processing. HTS 7226.91.25 applies to this other tool steel (<300mm wide), used for wear-resistant dies and inserts.
Hot-Rolled S7 Tool Steel Strip 120mm Wide
S7 shock-resisting tool steel hot-rolled strip, 120mm width, 3.5mm thick, untreated beyond hot-rolling. Classed in 7226.91.25 as tool steel alloy (<300mm wide), suited for punches and shear knives.