Nitronic 50 Stainless Steel Round Rod
Nitronic 50 (XM-19) austenitic stainless round rod with 11-14% nickel, diameter 35mm. Classifies to HTS 7222.30.00.24 as other stainless rods 8-<24% Ni, <152.4mm section. Used for valve stems in marine environments.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If >152.4mm cross-sectional dimension
Size-based statistical breakout within same nickel/content parameters.
If non-stainless alloy steel composition
Lacking minimum Cr for stainless definition per Chapter 72 moves to other alloy bars.
If imported as finished pump shafts
Machined to final transmission shaft spec becomes Chapter 84 parts.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Nitronic grades need galling resistance test data for proper end-use validation
• Cross-check if high Mn content (>8%) triggers alternative alloy note considerations
• Declare exact heat treatment condition (annealed vs aged) in entry docs
Related Products under HTS 7222.30.00.24
Custom 8-12% Nickel Stainless Square Rod
Hot-rolled square stainless rod engineered with 10% average nickel, 28mm x 28mm. Directly matches HTS 7222.30.00.24 parameters for other bars/rods stainless 8-<24% Ni <152.4mm. General fabrication stock.
Martensitic 8% Nickel Stainless Flat Strip
Martensitic precipitation stainless flat 'bar' 8% Ni, 5mm x 50mm cross-section. HTS 7222.30.00.24 as other stainless bars (non-angles) 8-<24% Ni <152.4mm. Knife blade stock.
AISI 321 Stainless Steel Round Bar
A round bar made from AISI 321 austenitic stainless steel containing approximately 10-12% nickel by weight, with a diameter of 25 mm (under 152.4 mm cross-section). This falls under HTS 7222.30.00.24 as other bars and rods of stainless steel with 8-24% nickel content and max cross-sectional dimension less than 152.4 mm. Commonly used in high-temperature exhaust systems due to its stabilized composition.
17-4 PH Stainless Steel Flat Bar
Precipitation-hardening 17-4 PH stainless steel flat bar with 10-13% nickel, 15mm thick x 100mm wide (max cross-section <152.4 mm). Classified under HTS 7222.30.00.24 for stainless steel bars with 8-24% nickel in 'other bars and rods' category. Ideal for aerospace structural components requiring high strength.
AISI 347 Stainless Steel Hexagonal Rod
Hexagonal rod of AISI 347 stainless steel with 9-13% nickel content, 40mm across flats (<152.4 mm cross-section). Fits HTS 7222.30.00.24 as other stainless steel rods/bars with moderate nickel alloying. Used in chemical processing equipment for corrosion resistance.
Duplex 2205 Stainless Steel Square Bar
Super duplex stainless square bar (modified S32750 variant with 8-12% nickel), 25mm square cross-section. HTS 7222.30.00.24 for stainless bars 8-<24% Ni, max dim <152.4mm. High strength for offshore oil platforms.