Martensitic 8% Nickel Stainless Flat Strip
Martensitic precipitation stainless flat 'bar' 8% Ni, 5mm x 50mm cross-section. HTS 7222.30.00.24 as other stainless bars (non-angles) 8-<24% Ni <152.4mm. Knife blade stock.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If different Ni range 0.17%C max
Suffixes break out carbon levels within Ni bands.
If >0.25mm thick electrical strip
Further worked electrical stainless sheets/strips.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Distinguish from razor blade steel dimensions/composition exactly
• Hardness testing may be required for martensitic grades
• Thickness uniformity critical for flat bar vs strip distinction
Related Products under HTS 7222.30.00.24
Custom 8-12% Nickel Stainless Square Rod
Hot-rolled square stainless rod engineered with 10% average nickel, 28mm x 28mm. Directly matches HTS 7222.30.00.24 parameters for other bars/rods stainless 8-<24% Ni <152.4mm. General fabrication stock.
AISI 321 Stainless Steel Round Bar
A round bar made from AISI 321 austenitic stainless steel containing approximately 10-12% nickel by weight, with a diameter of 25 mm (under 152.4 mm cross-section). This falls under HTS 7222.30.00.24 as other bars and rods of stainless steel with 8-24% nickel content and max cross-sectional dimension less than 152.4 mm. Commonly used in high-temperature exhaust systems due to its stabilized composition.
17-4 PH Stainless Steel Flat Bar
Precipitation-hardening 17-4 PH stainless steel flat bar with 10-13% nickel, 15mm thick x 100mm wide (max cross-section <152.4 mm). Classified under HTS 7222.30.00.24 for stainless steel bars with 8-24% nickel in 'other bars and rods' category. Ideal for aerospace structural components requiring high strength.
AISI 347 Stainless Steel Hexagonal Rod
Hexagonal rod of AISI 347 stainless steel with 9-13% nickel content, 40mm across flats (<152.4 mm cross-section). Fits HTS 7222.30.00.24 as other stainless steel rods/bars with moderate nickel alloying. Used in chemical processing equipment for corrosion resistance.
Duplex 2205 Stainless Steel Square Bar
Super duplex stainless square bar (modified S32750 variant with 8-12% nickel), 25mm square cross-section. HTS 7222.30.00.24 for stainless bars 8-<24% Ni, max dim <152.4mm. High strength for offshore oil platforms.
Nitronic 50 Stainless Steel Round Rod
Nitronic 50 (XM-19) austenitic stainless round rod with 11-14% nickel, diameter 35mm. Classifies to HTS 7222.30.00.24 as other stainless rods 8-<24% Ni, <152.4mm section. Used for valve stems in marine environments.