Custom 316LMod Stainless Hex Bar 10% Nickel
Modified 316L stainless hex bar with boosted 10% nickel for weldability, 20mm across flats. HTS 7222.30.00.24 for 8-24% Ni stainless bars/rods <152.4mm. For pharmaceutical fittings.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If Ni exceeds 24%
High-nickel super-austenitics have separate tariff treatment.
If not meeting stainless Cr threshold
Minimum 10.5% Cr required for stainless classification.
If as machined pump shafts
Functional completion for specific machinery shifts heading.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Pharma grades require 3.1 certs + FDA biocompatibility where applicable
• Verify no 'further worked' coatings per Chapter note definitions
• Batch traceability essential for recall scenarios
Related Products under HTS 7222.30.00.24
Custom 8-12% Nickel Stainless Square Rod
Hot-rolled square stainless rod engineered with 10% average nickel, 28mm x 28mm. Directly matches HTS 7222.30.00.24 parameters for other bars/rods stainless 8-<24% Ni <152.4mm. General fabrication stock.
Martensitic 8% Nickel Stainless Flat Strip
Martensitic precipitation stainless flat 'bar' 8% Ni, 5mm x 50mm cross-section. HTS 7222.30.00.24 as other stainless bars (non-angles) 8-<24% Ni <152.4mm. Knife blade stock.
AISI 321 Stainless Steel Round Bar
A round bar made from AISI 321 austenitic stainless steel containing approximately 10-12% nickel by weight, with a diameter of 25 mm (under 152.4 mm cross-section). This falls under HTS 7222.30.00.24 as other bars and rods of stainless steel with 8-24% nickel content and max cross-sectional dimension less than 152.4 mm. Commonly used in high-temperature exhaust systems due to its stabilized composition.
17-4 PH Stainless Steel Flat Bar
Precipitation-hardening 17-4 PH stainless steel flat bar with 10-13% nickel, 15mm thick x 100mm wide (max cross-section <152.4 mm). Classified under HTS 7222.30.00.24 for stainless steel bars with 8-24% nickel in 'other bars and rods' category. Ideal for aerospace structural components requiring high strength.
AISI 347 Stainless Steel Hexagonal Rod
Hexagonal rod of AISI 347 stainless steel with 9-13% nickel content, 40mm across flats (<152.4 mm cross-section). Fits HTS 7222.30.00.24 as other stainless steel rods/bars with moderate nickel alloying. Used in chemical processing equipment for corrosion resistance.
Duplex 2205 Stainless Steel Square Bar
Super duplex stainless square bar (modified S32750 variant with 8-12% nickel), 25mm square cross-section. HTS 7222.30.00.24 for stainless bars 8-<24% Ni, max dim <152.4mm. High strength for offshore oil platforms.