Duplex 2205 Stainless Cold Bar 16mm Round
Cold-drawn duplex 2205 stainless steel bar, 16 mm diameter with <8% nickel, for offshore platforms. Under HTS 7222.20.0041 as small cold-finished circular stainless rod. Combines austenitic/ferritic properties for high corrosion resistance.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If higher nickel duplex grades like 2205 variants
Precise nickel weight % determines subheading split in 7222.20 vs 7222.30.
If alloy but not qualifying as stainless
Non-stainless alloy bars with circular sections under 7214.
If for specific machinery parts in bulk
End-use determines Chapter 84 classification for parts of machines.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right HTS code — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Provide duplex microstructure verification; confirm diameter <18 mm with caliper certs
• Beware of partial heat treatment misdeclaration as further working
Related Products under HTS 7222.20.00.41
443 Stainless Cold Bar 12.8mm Circular
Automotive 443 stainless cold bar, 12.8 mm dia., <8% Ni for trim. HTS 7222.20.0041 stainless rod. ESR refined.
Cold-Drawn 304 Stainless Tie Bar 16.9mm
16.9 mm 304 stainless tie bar stock, cold-drawn <8% Ni for concrete forms. HTS 7222.20.0041. General corrosion resistance.
439LF Stainless Steel Cold Rod 17mm Diameter
Low-ferrite 439LF stainless cold rod, 17 mm round, <8% Ni for exhaust manifolds. HTS 7222.20.0041 for cold-finished stainless bars this size. Optimized weldability.
301 Full Hard Cold-Rolled Bar 10.5mm
Full hard condition 301 stainless bar, 10.5 mm dia., cold-rolled <8% Ni for springs. HTS 7222.20.0041 cold-finished stainless rod. High tensile strength.
Cold-Finished 304 Stainless Steel Round Bar 10mm
A cold-finished round bar of 304 stainless steel with a 10 mm diameter and less than 8% nickel content, not further worked beyond cold-forming. This falls under HTS 7222.20.0041 due to its circular cross-section under 18 mm, stainless steel composition, and minimal nickel. Commonly used in precision mechanical applications requiring corrosion resistance.
420 Stainless Cold-Finished Dowel Rod 14mm
14 mm 420 martensitic stainless dowel rod, cold-finished <8% Ni for hardened pins. HTS 7222.20.0041 small stainless bar. Corrosion resistant when hardened.