Nickel 6% Stainless Spring Stock
Spring temper stainless flat wire substitute, 80 mm wide, 0.4 mm thick, 6% nickel. HTS 7220.90.0015 other <600 mm stainless. For flat springs and clips.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If ball-bearing steel per note (h)
Specific spring alloys qualify separately.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Spring temper = cold work, not further worked unless coated
• Avoid wire declaration (7223)
• Ultimate tensile strength docs optional
Related Products under HTS 7220.90.00.15
310 Stainless Steel High-Temp Furnace Strip
310 heat-resistant stainless strip, 400 mm wide, 1.0 mm thick, 19-22% nickel, 24-26% Cr. HTS 7220.90.0015 other stainless flats <600 mm. Furnace muffles and radiant tubes.
Custom 15-5 PH Stainless Aerospace Sheet
15-5 PH martensitic PH stainless sheet, 300 mm wide, 2.5 mm thick, 3.5-5.5% nickel. HTS 7220.90.0015 other stainless <600 mm. Landing gear and structural aerospace.
AISI 304 Stainless Steel Strip for Appliances
Flat-rolled stainless steel strip of AISI 304 grade, width 500 mm, thickness 0.8 mm, containing 8-10.5% nickel and 18-20% chromium. Classified under HTS 7220.90.0015 as a flat-rolled product of stainless steel less than 600 mm wide, not elsewhere specified, with nickel content between 0.5% and 24%. Used primarily for fabricating kitchen appliance panels and trim.
Monel 400 Alloy Strip (Ni 65%)
Flat-rolled Monel 400 nickel-copper stainless strip, 550 mm wide, 0.6 mm thick, with approximately 65% nickel and copper balance. Classifies in HTS 7220.90.0015 as other stainless flat-rolled <600 mm with 0.5-24% nickel (effective for certain alloys). Used in marine hardware and valves.
Stainless Steel Edging Trim Stock
Flat-rolled stainless edging strip, 150 mm wide, 0.7 mm thick, 2-5% nickel alloy. HTS 7220.90.0015 for other stainless <600 mm flats. Stock for furniture and architectural trim fabrication.
Duplex 2205 Stainless Steel Plate Strip
Duplex 2205 (UNS S31803) flat strip, 500 mm wide, 2 mm thick, 4.5-6.5% nickel. Fits HTS 7220.90.0015 as other stainless flat-rolled <600 mm with qualifying nickel. High-strength for offshore platforms and pressure vessels.