AISI 304 Stainless Steel Strip for Appliances
Flat-rolled stainless steel strip of AISI 304 grade, width 500 mm, thickness 0.8 mm, containing 8-10.5% nickel and 18-20% chromium. Classified under HTS 7220.90.0015 as a flat-rolled product of stainless steel less than 600 mm wide, not elsewhere specified, with nickel content between 0.5% and 24%. Used primarily for fabricating kitchen appliance panels and trim.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If of a width of 600 mm or more
Flat-rolled stainless steel products 600 mm+ wide fall under heading 7222, regardless of nickel content.
If containing 0.5% or less nickel
Lower nickel content stainless steel (<0.5%) is classified in 7219 for flat-rolled products <600 mm wide.
If polished, coated, or further worked per chapter notes
Surface treatments like polishing or coating move product from 'other' to specifically worked categories in 7220.11.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Obtain mill test certificates verifying stainless steel composition, especially nickel (0.5-24%) and chromium content to confirm HTS 7220.90.0015 classification
• Ensure accurate width measurement (<600 mm) and declare as 'not further worked' if only basic hot/cold-rolled; polished strips may shift to 7220.11 or 7220.12
• Avoid common pitfall of misclassifying as tool steel if alloy exceeds chapter note (e) limits; standard 304 grade stays here
Related Products under HTS 7220.90.00.15
Nickel 6% Stainless Spring Stock
Spring temper stainless flat wire substitute, 80 mm wide, 0.4 mm thick, 6% nickel. HTS 7220.90.0015 other <600 mm stainless. For flat springs and clips.
310 Stainless Steel High-Temp Furnace Strip
310 heat-resistant stainless strip, 400 mm wide, 1.0 mm thick, 19-22% nickel, 24-26% Cr. HTS 7220.90.0015 other stainless flats <600 mm. Furnace muffles and radiant tubes.
Custom 15-5 PH Stainless Aerospace Sheet
15-5 PH martensitic PH stainless sheet, 300 mm wide, 2.5 mm thick, 3.5-5.5% nickel. HTS 7220.90.0015 other stainless <600 mm. Landing gear and structural aerospace.
Monel 400 Alloy Strip (Ni 65%)
Flat-rolled Monel 400 nickel-copper stainless strip, 550 mm wide, 0.6 mm thick, with approximately 65% nickel and copper balance. Classifies in HTS 7220.90.0015 as other stainless flat-rolled <600 mm with 0.5-24% nickel (effective for certain alloys). Used in marine hardware and valves.
Stainless Steel Edging Trim Stock
Flat-rolled stainless edging strip, 150 mm wide, 0.7 mm thick, 2-5% nickel alloy. HTS 7220.90.0015 for other stainless <600 mm flats. Stock for furniture and architectural trim fabrication.
Duplex 2205 Stainless Steel Plate Strip
Duplex 2205 (UNS S31803) flat strip, 500 mm wide, 2 mm thick, 4.5-6.5% nickel. Fits HTS 7220.90.0015 as other stainless flat-rolled <600 mm with qualifying nickel. High-strength for offshore platforms and pressure vessels.