430 Cold-Rolled Stainless Steel Sheet 2.5mm Thick
Ferritic 430 grade stainless steel sheet, cold-rolled to 2.5 mm thickness, width 1000 mm, not further worked. HTS 7219.33.00 applies to all stainless flat-rolled products meeting width, thickness, and cold-rolled criteria regardless of specific alloy.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If alloy steel but not stainless
Non-stainless alloy flat-rolled products over 600mm width classify under Chapter 72 heading 7212, not stainless-specific 7219.
If narrow width under 600 mm
Stainless flat-rolled products less than 600 mm wide move to heading 7225.
If hot-rolled and thickness under 3 mm
Hot-rolled processing in same thickness range uses 7219.13 subheading.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Label clearly as 'not further worked' and provide surface inspection photos if requested
• Common issue: temporary storage films mistaken for coatings—remove before entry
• Verify ferritic structure doesn't qualify as excluded 'tool steel' per US Chapter Note (e)
Related Products under HTS 7219.33.00
304 Cold-Rolled Stainless Steel Sheet 2mm Thick
Flat-rolled 304 stainless steel sheet, cold-rolled, with thickness of 2 mm and width over 600 mm, not further worked beyond cold-reduction. Classifies under HTS 7219.33.00 due to stainless steel composition, specified thickness range (1-3 mm), and lack of additional surface treatments like polishing or coating.
316L Cold-Reduced Stainless Steel Plate 1.5mm
Cold-reduced 316L stainless steel flat-rolled product, 1.5 mm thick, width exceeding 600 mm, used in chemical processing equipment. Fits HTS 7219.33.00 as stainless steel, cold-rolled without further working, within 1-3 mm thickness per chapter definitions.
201 Cold-Rolled Stainless Steel Coil 1.8mm
Austenitic 201 stainless steel cold-rolled coil, 1.8 mm thick, 1500 mm width, supplied in master coils for slitting. Classifies precisely under 7219.33.00 for cold-reduced stainless flat products, thickness 1-3 mm, wide format, no further working.
321 Cold-Rolled Stainless Steel Sheet 1.2mm
Stabilized 321 stainless steel cold-rolled sheet for high-temperature service, 1.2 mm thickness, 1250 mm width. Meets HTS 7219.33.00 criteria: stainless, cold-reduced only, 1-3 mm thick, coilable width over 600 mm.
409 Cold-Rolled Stainless Steel Automotive Sheet 2.2mm
Ferritic 409 stainless steel sheet cold-rolled for exhaust components, 2.2 mm thick, 1200 mm width. HTS 7219.33.00 classification based on stainless steel, cold-rolled process only, thickness exceeding 1 mm but under 3 mm.
304L Cold-Rolled Stainless Steel Mill Edge Sheet 1.6mm
Low-carbon 304L stainless cold-rolled sheet with mill edges, 1.6 mm gauge, 1524 mm width for appliance manufacturing. Falls under HTS 7219.33.00 as not further worked cold-reduced stainless flat-rolled product in specified thickness.