17-4 PH Precipitation Hardening Stainless Sheet 3.6mm
Precipitation-hardening 17-4 PH stainless steel cold-rolled sheet at 3.6 mm thickness, over 600 mm wide, not further worked. HTS 7219.32.00 covers this cold-reduced stainless flat product due to thickness specs and absence of cladding or enameling.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If under 3 mm but over 600 mm width
Thickness below 3 mm for wide cold-rolled stainless shifts to 7219.21 subheading.
If narrower coils under 600 mm
Coiled stainless cold-rolled products narrower than 600 mm classify under 7220.12.
If high-strength steel criteria met
Meets high-strength steel note (a) yield point? Then classifies as 7208 flat-rolled iron/steel.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Document PH grade composition to distinguish from standard stainless; inspect for any borating treatments
• Ensure entry before rust/discoloration per Chapter note on no duty allowance
Related Products under HTS 7219.32.00
409 Cold-Rolled Stainless Steel Sheet 3.9mm Thick
Ferritic automotive-grade Type 409 stainless sheet cold-rolled to 3.9 mm, width 600 mm or more, plain cold-reduced surface. Classifies under HTS 7219.32.00 for thickness-specific cold-rolled stainless flat-rolled products, used in exhaust systems.
Type 304 Cold-Rolled Stainless Steel Sheet 3.5mm Thick
Flat-rolled stainless steel sheet of Type 304 alloy, cold-rolled to a thickness of 3.5 mm and width exceeding 600 mm, not further worked beyond cold-reduction. This product falls under HTS 7219.32.00 due to its stainless steel composition, specified thickness range of 3-4.75 mm, and lack of additional surface treatments like polishing or coating. Commonly used in industrial fabrication requiring corrosion resistance.
Type 316L Cold-Rolled Stainless Steel Plate 4mm Thick
Cold-reduced stainless steel plate of low-carbon Type 316L, measuring 4 mm thick with width over 600 mm, supplied in not further worked condition. Classified in HTS 7219.32.00 for its cold-rolled stainless steel properties within the 3-4.75 mm thickness band, ideal for marine and chemical processing equipment.
430 Cold-Rolled Stainless Steel Sheet 3.2mm Thick
Ferritic Type 430 stainless steel flat-rolled sheet, cold-rolled to 3.2 mm thickness and minimum 600 mm width, without further processing. HTS 7219.32.00 applies to this cold-reduced stainless product in the designated thickness range, suitable for automotive trim and appliance exteriors.
Duplex 2205 Cold-Rolled Stainless Steel Sheet 3.8mm
High-strength Duplex 2205 stainless steel sheet, cold-rolled to 3.8 mm thick with width of 600 mm or more, not subjected to further working. Fits HTS 7219.32.00 precisely for cold-reduced stainless flat-rolled products in this thickness, used in oil & gas piping.
310 Cold-Rolled Stainless Steel Sheet 4.2mm Thick
High-temperature Type 310 stainless steel flat-rolled sheet, cold-rolled to 4.2 mm thickness exceeding 600 mm width, without additional surface treatments. Directly matches HTS 7219.32.00 for cold-reduced stainless in 3-4.75 mm range, for furnace and heat exchanger parts.