Hot-Rolled Low-Carbon Steel Rebar Substitute Rod 5/8 Inch
5/8 inch plain round rod of hot-rolled nonalloy steel <0.25% carbon, used where mild steel needed instead of deformed rebar. HTS 7214.99.0060 for low-carbon bars lacking reinforcing deformations.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If produced with ribs/indentations during rolling
Becomes concrete reinforcing bar per note (c).
If deformed bars with >=0.25% carbon
Carbon content plus deformation moves to 7213.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Plain surface critical - any deformation risks 7214.20 reclassification
• Grade documentation (e.g
• ASTM A615 Grade 40 equivalent)
• Length consistency for construction bundle entry
Related Products under HTS 7214.99.00.60
Hot-Extruded Low-Carbon Steel Square Bar 2x2 Inch
A 2x2 inch square bar of nonalloy steel with less than 0.25% carbon, hot-extruded and supplied in straight lengths without further processing. Classified under HTS 7214.99.0060 for other low-carbon nonalloy steel bars not further worked than hot-extruded.
Forged Low-Carbon Steel Flat Bar 1/4 x 3 Inch
Flat bar measuring 1/4 inch thick by 3 inches wide, forged from nonalloy low-carbon steel (<0.25% C), not further worked. HTS 7214.99.0060 covers forged bars of this composition excluding twisted reinforcing types.
Twisted Low-Carbon Steel Merchant Bar 1 Inch Round
1-inch round merchant bar of nonalloy steel <0.25% carbon, lightly twisted after hot-rolling but without reinforcing deformations. HTS 7214.99.0060 includes such twisted bars if not qualifying as concrete reinforcement.
Hot-Rolled Low-Carbon Steel Billet Section 4x4 Inch
Square 4x4 inch section bar from hot-rolled nonalloy low-carbon steel (<0.25% C), used as billet stock, not further worked. Classifies in HTS 7214.99.0060 for other such bars excluding specific shapes.
Low-Carbon Steel Hot-Rolled Angle Bar 2x2x1/4 Inch
L-shaped angle bar 2x2x1/4 inch from hot-rolled nonalloy steel <0.25% carbon, not further worked. While angles have specific codes, simple merchant angles fit 'other' 7214.99.0060 if not structural grade.
Hot-Rolled Low-Carbon Steel Shafting Bar 1-1/2 Inch Round
Round shafting bar 1-1/2 inch diameter, hot-rolled from nonalloy low-carbon steel (<0.25% C), straight and not machined. HTS 7214.99.0060 for other low-carbon hot-rolled bars used in machinery.