Hot-Rolled Low-Carbon Steel Billet Section 4x4 Inch
Square 4x4 inch section bar from hot-rolled nonalloy low-carbon steel (<0.25% C), used as billet stock, not further worked. Classifies in HTS 7214.99.0060 for other such bars excluding specific shapes.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If considered semi-finished billet/ingot >4 sides
Semi-finished iron/nonalloy steel products in 7207 if not fully rolled to bar form.
If circular cross-section 14mm+ diameter, other carbon levels
Specific statistical breakout for larger rounds in higher carbon ranges.
If alloy steel cold-finished condition
Even low-carbon alloys go to 7225 if cold-worked.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Confirm bar vs semi-finished status; sections > certain sizes risk 7207 classification
• Mill certificates must specify exact carbon analysis and nonalloy status
• Avoid coated/rusted shipments - no duty reduction for pre-entry damage
Related Products under HTS 7214.99.00.60
Hot-Extruded Low-Carbon Steel Square Bar 2x2 Inch
A 2x2 inch square bar of nonalloy steel with less than 0.25% carbon, hot-extruded and supplied in straight lengths without further processing. Classified under HTS 7214.99.0060 for other low-carbon nonalloy steel bars not further worked than hot-extruded.
Forged Low-Carbon Steel Flat Bar 1/4 x 3 Inch
Flat bar measuring 1/4 inch thick by 3 inches wide, forged from nonalloy low-carbon steel (<0.25% C), not further worked. HTS 7214.99.0060 covers forged bars of this composition excluding twisted reinforcing types.
Twisted Low-Carbon Steel Merchant Bar 1 Inch Round
1-inch round merchant bar of nonalloy steel <0.25% carbon, lightly twisted after hot-rolling but without reinforcing deformations. HTS 7214.99.0060 includes such twisted bars if not qualifying as concrete reinforcement.
Low-Carbon Steel Hot-Rolled Angle Bar 2x2x1/4 Inch
L-shaped angle bar 2x2x1/4 inch from hot-rolled nonalloy steel <0.25% carbon, not further worked. While angles have specific codes, simple merchant angles fit 'other' 7214.99.0060 if not structural grade.
Hot-Rolled Low-Carbon Steel Shafting Bar 1-1/2 Inch Round
Round shafting bar 1-1/2 inch diameter, hot-rolled from nonalloy low-carbon steel (<0.25% C), straight and not machined. HTS 7214.99.0060 for other low-carbon hot-rolled bars used in machinery.
Low-Carbon Hot-Extruded Steel Hollow Bar 3 Inch OD
Hollow drill bar 3 inch outer diameter, hot-extruded nonalloy steel <0.25% carbon, not further worked, used for tooling. Fits HTS 7214.99.0060 as other low-carbon extruded bars (hollow if not tube).