Hot-Extruded Low-Carbon Steel Square Bar 2x2 Inch
A 2x2 inch square bar of nonalloy steel with less than 0.25% carbon, hot-extruded and supplied in straight lengths without further processing. Classified under HTS 7214.99.0060 for other low-carbon nonalloy steel bars not further worked than hot-extruded.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If circular cross-section with diameter <14mm (including twisted)
Specific subheading for smaller round/twisted low-carbon bars in 7214.99.0030 takes precedence.
If further cold-worked after hot-rolling (cold-drawn, etc.)
Exceeds 'not further worked than hot-rolled' limitation, moving to cold-worked bars in 7215.
If imported as fabricated structural steel sections
If shaped for structural use (angles, channels), classifies under Chapter 73 articles, not Chapter 72 bars.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide heat analysis confirming nonalloy composition and carbon <0.25% to Customs at entry
• Avoid shipments with any surface treatments like phosphatizing, as 'further worked' per chapter note excludes from 7214
• Measure dimensions accurately; bars over specific sizes may trigger statistical suffixes or different reporting
Related Products under HTS 7214.99.00.60
Forged Low-Carbon Steel Flat Bar 1/4 x 3 Inch
Flat bar measuring 1/4 inch thick by 3 inches wide, forged from nonalloy low-carbon steel (<0.25% C), not further worked. HTS 7214.99.0060 covers forged bars of this composition excluding twisted reinforcing types.
Twisted Low-Carbon Steel Merchant Bar 1 Inch Round
1-inch round merchant bar of nonalloy steel <0.25% carbon, lightly twisted after hot-rolling but without reinforcing deformations. HTS 7214.99.0060 includes such twisted bars if not qualifying as concrete reinforcement.
Hot-Rolled Low-Carbon Steel Billet Section 4x4 Inch
Square 4x4 inch section bar from hot-rolled nonalloy low-carbon steel (<0.25% C), used as billet stock, not further worked. Classifies in HTS 7214.99.0060 for other such bars excluding specific shapes.
Low-Carbon Steel Hot-Rolled Angle Bar 2x2x1/4 Inch
L-shaped angle bar 2x2x1/4 inch from hot-rolled nonalloy steel <0.25% carbon, not further worked. While angles have specific codes, simple merchant angles fit 'other' 7214.99.0060 if not structural grade.
Hot-Rolled Low-Carbon Steel Shafting Bar 1-1/2 Inch Round
Round shafting bar 1-1/2 inch diameter, hot-rolled from nonalloy low-carbon steel (<0.25% C), straight and not machined. HTS 7214.99.0060 for other low-carbon hot-rolled bars used in machinery.
Low-Carbon Hot-Extruded Steel Hollow Bar 3 Inch OD
Hollow drill bar 3 inch outer diameter, hot-extruded nonalloy steel <0.25% carbon, not further worked, used for tooling. Fits HTS 7214.99.0060 as other low-carbon extruded bars (hollow if not tube).