Pipe Making Hot-Rolled Skelp 2.8mm x 580mm Mill Edge
Skelp is hot-rolled coil specifically for welded pipe/tube production, 2.8mm wall thickness capability, 580mm width (<600mm), untrimmed. HTS 7211.19.75.30 for this not-further-worked nonalloy narrow coil.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If ball-bearing steel
Specific alloy for bearings (US Note 72(h)) gets separate statistical reporting even in same base HTS.
If formed into tubes/pipes
Welded/formed into tubes/pipes completes manufacture, classifying under Chapter 73 tubes.
If electrolytically coated
Electroplating/metal coating constitutes further working, requiring Chapter 72 coated steel headings.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Skelp chemistry optimized for welding - document C/Mn/Si ratios confirming nonalloy status
• Width critical for pipe diameter - under 600mm strictly for this subheading
• Mill test reports must trace coil from melt through rolling preserving edge condition
Related Products under HTS 7211.19.75.30
Hot-Rolled Non-Alloy Steel Coil 1.5mm Thick 500mm Wide Untrimmed Edges
This is a flat-rolled product of nonalloy steel, hot-rolled, in coils, with a width of 500 mm (less than 600 mm), and featuring untrimmed mill edges. It falls under HTS 7211.19.75.30 because it is not further worked beyond hot-rolling, not clad, plated, or coated, and specifically has untrimmed edges as produced during rolling.
HRPO Base Steel Coil 2.0mm x 450mm Wide Mill Edge
Hot-rolled nonalloy steel coil used as base material before pickling (HRPO process), 2.0mm thick, 450mm wide, with untrimmed edges. Classified under HTS 7211.19.75.30 as hot-rolled not further worked, in coils under 600mm width with characteristic untrimmed edges.
Hot-Rolled Mild Steel Slit Coil 1.2mm x 380mm Untrimmed
Low-carbon mild steel hot-rolled into coils, 1.2mm thickness, 380mm width, retaining untrimmed edges typical of primary mill production. HTS 7211.19.75.30 applies to these narrow nonalloy steel coils not further worked beyond hot-rolling.
Nonalloy Steel Hot Band Coil 3mm x 550mm Mill Edge
Hot band refers to primary hot-rolled steel coil directly from rolling mill, 3mm thick, 550mm wide (<600mm), untrimmed edges. Perfectly matches HTS 7211.19.75.30 for not further worked, nonalloy, narrow coil with mill edges.
Pickle Line Feed Stock Steel Coil 1.8mm x 420mm Untrimmed
Hot-rolled nonalloy steel coil prepared for pickling line processing, 1.8mm gauge, 420mm width, untrimmed mill edges preserved. HTS 7211.19.75.30 covers this not-further-worked narrow coil product before any surface treatments.
Automotive Stamping Blank Hot-Rolled Coil 2.5mm x 480mm Mill Edge
Hot-rolled nonalloy steel coil for automotive outer body panel stamping, 2.5mm thick, 480mm wide, untrimmed edges. Classifies under HTS 7211.19.75.30 as basic hot-rolled coil not further worked, narrow width.