Birch Sawn Flitches in Rough Form
Rough birch flitches (Betula spp.) with minimum 15 cm cross-section, minimally squared for log stability during transport. HTS 4403.95.01 applies as these are wood in the rough, not yet finely sawn or planed.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If coniferous and sawn to thickness over 6mm
Chapter notes distinguish coniferous sawn wood; birch is nonconiferous but processing matters.
If of pine (Pinus spp.) instead of birch
Species-specific coniferous rough wood heads like 4403.12 apply to pine.
If reconstructed into cellular wood panels
Agglomerated or molded birch becomes reconstructed wood under 4418.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Document rough state with photos/measurements to avoid reclassification as sawn timber
• Check for bark/sapwood removal compliance per HTS heading description
• Use heat-treated markings for ISPM 15 to facilitate customs clearance
Related Products under HTS 4403.95.01
Birch Logs for Veneer Production
Rough-cut birch (Betula spp.) logs with a minimum cross-sectional dimension of 15 cm, stripped of bark but not further processed. These fall under HTS 4403.95.01 as wood in the rough, specifically birch meeting the size requirement for large timber used in high-quality veneer slicing.
Large Birch Timber Blocks
Roughly squared birch wood blocks from Betula spp., each with smallest cross-section 15 cm or greater, suitable for furniture lumber. Classified in HTS 4403.95.01 due to rough state and birch species with specified large dimensions.
Industrial Birch Cant Blocks
Large cant blocks of birch (Betula spp.) in rough-squared condition, smallest cross-section 15 cm+, used for beam production. Fits HTS 4403.95.01 for oversized birch rough wood from mechanical processing.
Birch Roundwood for Pulpwood
Unstripped or partially debarked birch roundwood (Betula spp.), diameter 15 cm minimum cross-section, destined for pulp mills. HTS 4403.95.01 covers this large-dimension birch in rough state.
Oversized Birch Debarked Logs
Debarked birch logs (Betula spp.) with smallest cross-section 15 cm or more, in rough form for sawmill feed. Precisely matches HTS 4403.95.01 for large birch rough wood.