Copper Water Inlet Manifold for Storage Water Heaters
Precision-machined copper manifold distributing cold inlet water evenly in non-electric storage tank water heaters. Falls under HTS 8419.90.10.00 as a dedicated part for storage water heaters maintaining temperature via insulated tanks. Corrosion-resistant design suits prolonged hot water retention.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If generic copper pipe fittings without heater design
Standard copper tubes/fittings for plumbing classify under Chapter 74, lacking water heater specificity.
If parts of electric tankless (instantaneous) models
Electric instantaneous heaters use different high-flow manifolds, falling under general parts.
If functions primarily as pressure regulator valve
Valve-dominant manifolds classify as taps/valves if regulation exceeds distribution role.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Certify copper alloy composition (e.g
• C12200) meets water heater pressure standards per ASME codes
• Pair with tank diagrams showing manifold integration to substantiate 8419 classification over generic plumbing
• Avoid misdeclaration as pipe fittings; emphasize thermal expansion joints specific to heater operation
Related Products under HTS 8419.90.10.00
Stainless Steel Heat Exchanger Coil for Instantaneous Water Heaters
This coiled stainless steel tube assembly transfers heat from combustion gases to water in tankless instantaneous water heaters. It is a core component classified under HTS 8419.90.10.00 as a part specifically designed for non-electric instantaneous water heaters. The part enables rapid heating without storage, distinguishing it from domestic heater components.
Dip Tube for Cold Water Storage Heaters
Plastic or copper dip tube directing incoming cold water to tank bottom in storage water heaters. Under HTS 8419.90.10.00 as it promotes thermal layering for efficiency in non-electric units. Prevents mixing with hot water above.
Insulation Jacket Blanket for Storage Water Heater
Fiberglass blanket with foil facing designed to wrap storage water heater tanks reducing standby loss. Classifies in HTS 8419.90.10.00 as thermal part enhancing non-electric storage heater efficiency. Meets Energy Star thermal resistance specs.
Burner Assembly for Gas Instantaneous Water Heaters
A pre-assembled gas burner manifold with injectors and ignition components for non-electric tankless water heaters. Classified in HTS 8419.90.10.00 as it is integral to the combustion process in instantaneous water heaters. Enables on-demand hot water production through direct flame heating.
Flue Exhaust Pipe Assembly for Instantaneous Gas Heaters
Stainless steel concentric flue pipe set venting combustion exhaust while drawing intake air in tankless water heaters. HTS 8419.90.10.00 applies as essential safety part for non-electric instantaneous heaters. Design prevents carbon monoxide buildup during on-demand operation.
Anode Rod for Storage Water Heater Tanks
Magnesium sacrificial anode rod mounted inside storage water heater tanks to prevent corrosion. Classified under HTS 8419.90.10.00 as a critical longevity part for non-electric storage water heaters. Sacrifices itself to protect tank steel from galvanic degradation.