Galvanized Steel Flagpole Base with Coupling

4-inch (101.6 mm) OD heavy-wall galvanized tube with ground sleeve coupling for residential flagpoles. Fits HTS 7306.30.50.27 specifications for welded galvanized circular tubes, nonalloy steel, with coupling in 50.8-114.3 mm OD range.

Import Duty Rates by Country of Origin

Origin CountryMFN RateCh.99 SurchargesTotal Effective Rate
🇨🇳ChinaFree+35.0%35%
🇲🇽MexicoFree+10.0%10%
🇨🇦CanadaFree+10.0%10%
🇩🇪GermanyFree+10.0%10%
🇯🇵JapanFree+10.0%10%

Alternative Classifications

This product could be classified differently depending on its characteristics or intended use.

7308.40.00Same rate: 35%

If equipment-specific poles

Dedicated flagpole equipment has separate provisions.

7616.99.51Higher: 37.5% vs 35%

If aluminum construction

Common flagpole material shifts to Chapter 76.

7326.90Lower: 12.9% vs 35%

If prefabricated into complete pole

Finished poles become other steel articles.

Not sure which classification is right?

Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.

Import Tips & Compliance

Wind load ratings must accompany structural calculations

Concrete-filled bases may classify differently as composite articles

Retail packaging triggers consumer product safety rules

Related Products under HTS 7306.30.50.27

Galvanized Steel Fence Post with Coupling

A welded galvanized steel tube with an outside diameter of 2.5 inches (63.5 mm), wall thickness over 1.65 mm, and pre-attached coupling for connecting fence sections. Classified under HTS 7306.30.50.27 due to its galvanized finish, circular cross-section, welded construction from nonalloy steel, and inclusion of coupling. Primarily used in agricultural and residential fencing.

Galvanized Steel Guardrail Tube with Coupling

Welded galvanized tube, 3-inch (76.2 mm) OD, wall thickness 2 mm, with end coupling for highway guardrail assembly. Fits HTS 7306.30.50.27 as other galvanized welded circular tubes of nonalloy steel exceeding 50.8 mm OD up to 114.3 mm, imported with coupling.

Galvanized Steel Plumbing Riser with Coupling

2-inch (50.8 mm) OD galvanized welded steel riser pipe with threaded coupling for water supply lines in buildings. HTS 7306.30.50.27 applies to its galvanized, welded, circular nonalloy steel construction, wall >1.65 mm, OD 50.8-114.3 mm, imported coupled.

Galvanized Steel Trellis Pole with Coupling

Welded galvanized tube, 2.375-inch (60.3 mm) OD, 14-gauge wall (1.9 mm thick), with spear-point coupling for garden trellises. Under HTS 7306.30.50.27 for galvanized nonalloy welded circular tubes with coupling in specified diameter range.

Galvanized Steel Handrail Section with Coupling

3.5-inch (88.9 mm) OD schedule 40 galvanized welded pipe with swage coupling for porch/stair handrails. Classifies in HTS 7306.30.50.27 as other galvanized welded circular tubes of iron/nonalloy steel, wall ≥1.65 mm, OD 50.8-114.3 mm, with coupling.

Galvanized Steel Sprinkler Pipe with Coupling

2-inch (50.8 mm) OD galvanized welded steel pipe with threaded coupling for agricultural irrigation systems. HTS 7306.30.50.27 due to galvanized finish, circular welded nonalloy steel, wall thickness >1.65 mm, diameter specs, imported with coupling.