Hot-Rolled Alloy Steel L-Angle 100x100x10mm
A hot-rolled L-shaped structural section made from alloy steel with a maximum cross-sectional dimension of 100 mm, used in construction framing. Classified under HTS 7228.70.30.41 as hot-rolled angles, shapes, and sections of alloy steel, not drilled, punched, or further advanced beyond rolling, with cross-section 76 mm or more. Meets Chapter 72 definition for alloy steel due to added elements like chromium and molybdenum.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If made of non-alloy steel
Non-alloy steel angles/shapes fall under Chapter 72 heading 7216, while alloy steel uses 7228 due to specific alloying elements.
If maximum cross-sectional dimension under 76 mm
Smaller cross-sections shift to different statistical suffix within same heading for precise dimension-based classification.
If fabricated into assembled structures
Further assembly into frameworks or supports moves to Chapter 73 as fabricated metal structures rather than primary shapes.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Certify alloy steel composition to distinguish from carbon steel; ensure mill test reports confirm hot-rolled state without advanced processing
• Verify maximum cross-sectional dimension ≥76 mm to avoid subheadings
• No duty allowance for surface rust per Chapter 72 notes
Related Products under HTS 7228.70.30.41
Alloy Steel HSS Hollow Section 150x150x12mm Hot-Rolled
Hot-rolled hollow structural section (HSS) of alloy steel, square profile with 150 mm outer dimension, for load-bearing columns in buildings. Fits HTS 7228.70.30.41 as 'shapes and sections' of alloy steel, hot-rolled without drilling, punching, or advancement, cross-section over 76 mm. Excludes hollow drill bars specifically noted elsewhere.
Hot-Rolled Alloy Steel U-Channel 200x75x10mm
U-shaped channel section of hot-rolled alloy steel, 200 mm height with max cross-section over 76 mm, used in structural beams for bridges. Under HTS 7228.70.30.41 for hot-rolled alloy steel shapes/sections, not drilled/punched/advanced. Alloy per Chapter 72 notes with elements enhancing strength.
Alloy Steel T-Section 125x125x12mm Hot-Rolled
T-profile hot-rolled section from alloy steel, maximum dimension 125 mm, for crane runway supports. HTS 7228.70.30.41 applies to such 'other' hot-rolled alloy shapes/sections ≥76 mm cross-section, no advanced processing.
Hot-Rolled Alloy Steel Z-Purlin 150x50x3mm Thick
Z-shaped purlin profile of alloy steel, hot-rolled with 150 mm max dimension, for roofing support in industrial buildings. Classed in HTS 7228.70.30.41 as hot-rolled 'other' shapes/sections of alloy steel ≥76 mm.
Alloy Steel Unequal Angle 200x100x15mm Hot-Rolled
Unequal leg L-angle from hot-rolled alloy steel, 200x100 mm profile exceeding 76 mm cross-section, used in shipbuilding. HTS 7228.70.30.41 for such unadvanced alloy angles/shapes.