Cold-Rolled 15-5 PH Stainless Alloy Bar 195 mm
15-5 PH martensitic precipitation hardening stainless bar, cold-rolled finish 195 mm diameter for pump shafts. Under HTS 7228.50.5040 as other cold-finished alloy steel 76-228 mm. Chromium qualifies alloy status.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If specific stainless steel cold bar
Stainless steel bars cold-finished have dedicated Chapter 72 stainless provisions.
If pump shaft components
Machined pump parts classified as machinery parts in Chapter 84.
If hot-rolled equivalent
Processing method splits hot vs cold within alloy steel headings.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• PH stainless may classify as alloy steel or stainless - chemistry determines
• Near upper size limit (228 mm max) demands accurate measurement
• Condition H900/H1025 must show as heat treated bar form only
Related Products under HTS 7228.50.50.40
Cold-Finished 4140 Alloy Steel Round Bar 100 mm Diameter
A cold-finished round bar made from 4140 chrome-molybdenum alloy steel with a 100 mm diameter, used in machinery and automotive axles. Classified under HTS 7228.50.5040 as other bars and rods of alloy steel, not further worked than cold-formed or cold-finished, with cross-section between 76-228 mm. Meets alloy steel definition due to chromium and molybdenum content exceeding chapter note thresholds.
Cold-Formed 4340 Alloy Steel Shaft Bar 150 mm Diameter
Cold-formed 4340 nickel-chromium-molybdenum alloy steel bar with 150 mm diameter, ideal for aircraft landing gear and heavy machinery shafts. Falls under HTS 7228.50.5040 for other cold-finished alloy steel bars with 76-228 mm cross-section. Alloy status confirmed by elevated Cr, Ni, and Mo per Chapter 72 definitions.
Cold-Finished 8620 Alloy Steel Round Bar 80 mm Diameter
Cold-finished 8620 carburizing alloy steel bar, 80 mm diameter, used for gears and pinions in transmissions. HTS 7228.50.5040 applies to cold-formed alloy steel rods in 76-228 mm range, not further worked. Chromium and nickel content qualifies as alloy steel.
17-4 PH Stainless Alloy Steel Bar 120 mm Cross-Section
Cold-finished 17-4 PH precipitation-hardening stainless steel bar with 120 mm square cross-section for aerospace and valve stems. Under HTS 7228.50.5040 as other cold-finished alloy steel bars 76-228 mm, not further worked. High chromium qualifies under alloy steel definitions.
Cold-Formed Tool Steel H13 Round Bar 200 mm Diameter
H13 hot-work tool steel bar, cold-formed with 200 mm diameter for die casting molds and extrusion tooling. HTS 7228.50.5040 covers cold-finished other alloy steel bars 76-228 mm. Meets Chapter 72 note (e) tool steel criteria with high Cr and Mo content.
Cold-Finished 300M Alloy Steel Bar 90 mm Diameter
300M ultra-high strength alloy steel bar, cold-finished 90 mm diameter for aircraft landing gear components. Classified HTS 7228.50.5040 as other cold-finished alloy steel, 76-228 mm cross-section. Ni-Cr-Mo composition exceeds alloy thresholds.