O1 Cold-Reduced Tool Steel Strip
Cold-reduced strip of O1 tool steel (0.9% C, 1% Mn, 1% Cr), 250 mm wide, 0.8 mm thick, in coils, not further worked. HTS 7226.92.30 applies as tool steel per note (e)(iii) with ≥0.85% C and 1-1.8% Mn, width <300 mm.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If width 300-600 mm
Same cold-rolled tool steel but wider dimension shifts to sibling subheading 7226.92.50 with potentially different rates.
If for retail sale in small coils as consumer craft material
If marketed for non-industrial end-use and not certified as tool steel, may classify as general cold-rolled alloy in 7210 rather than specialized 7226.
If clad or coated with plastics post-rolling
Cladding or nonmetallic coatings constitute 'further worked' per Chapter notes, redirecting to 7226.99.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Submit affidavits confirming no heat treatment or coating; CBP scrutinizes for 'further worked' violations
• Verify strip vs. sheet distinction; narrow strips may qualify for lower-duty subheadings if mismeasured
Related Products under HTS 7226.92.30
D2 Cold-Rolled Tool Steel Sheet
Cold-rolled flat-rolled sheet of D2 tool steel (1.5% C, 12% Cr), width 200 mm, thickness 1.5 mm, not further worked beyond cold reduction. Classified under HTS 7226.92.30 as tool steel per U.S. note (e)(i) with >1.2% C and >10.5% Cr, width <300 mm.
A2 Cold-Rolled Tool Steel Plate
Cold-rolled plate of A2 tool steel (1% C, 5.25% Cr), 150 mm width, 2 mm thick, not in coils. Meets HTS 7226.92.30 as tool steel note (e)(ii): ≥0.3% C and 1.25-10.5% Cr, width <300 mm, cold-rolled only.
M2-Equivalent Cold-Rolled Tool Steel
Cold-rolled sheet of M2-type tool steel (0.85% C, 4% Cr, 5% Mo), 180 mm width. Fits HTS 7226.92.30: tool steel note (e)(ii)/(v), cold-reduced only, <300 mm wide for cutting tools.
CPM-M4 Cold-Reduced Tool Steel Sheet
Powder metallurgy CPM-M4 tool steel cold-reduced sheet, 280 mm wide, 1.2 mm thick, for dies. HTS 7226.92.30 for cold-rolled tool steel per note (e)(i)/(ii), width <300 mm, no further working like polishing.
S7 Cold-Rolled Tool Steel Strip
S7 shock-resisting tool steel cold-rolled strip, 100 mm width, 1 mm thick, for punches. Classifies HTS 7226.92.30: tool steel note (e)(v) ≥0.5% C and ≥3.5% Mo, cold-reduced, <300 mm wide.
H13 Cold-Reduced Tool Steel Sheet
H13 hot-work tool steel cold-reduced sheet, 220 mm wide, 2.5 mm thick, for molds. HTS 7226.92.30 as cold-rolled tool steel note (e)(ii): ≥0.3% C, 5% Cr, width <300 mm, no coatings.