Narrow Hot-Rolled Alloy Steel for Tool Manufacturing
Hot-rolled alloy steel flat products, width under 300 mm and thickness below 4.75 mm, used in tool production. Fits HTS 7226.91.80.00 as 'other' hot-rolled alloy steel not further worked, distinguishing from high-strength or tool steel specifics in notes.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If qualifies as tool steel per note (e)
Tool steels with specific alloy combinations like >1.2% carbon and >10.5% Cr move to Chapter 72 tool steel headings.
If further worked like coated or polished
Any surface treatment (e.g., phosphatizing) per chapter note classifies as 'further worked' under 7226.99.
If rectangular bars rather than flat-rolled
If processed into bars > thickness but rectangular cross-section, it falls under bars and rods in 7213.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Confirm not 'tool steel' per note (e) via chemical analysis; misclassification to 7228 can occur without certification
• Document hot-rolling process only; any polishing or coating makes it 'further worked' under Chapter 72 definition
• Use precise calipers for thickness verification; entries over 4.75mm shift to different statistical suffix
Related Products under HTS 7226.91.80.00
Hot-Rolled Alloy Steel Strip for Automotive Springs
Hot-rolled flat-rolled alloy steel strip, less than 300 mm wide and under 4.75 mm thick, not further worked beyond hot-rolling. Classified under HTS 7226.91.80.00 due to its alloy steel composition, narrow width, and hot-rolled state without additional processing like cold-rolling or coating.
Hot-Rolled Silicon-Manganese Alloy Steel Banding
Narrow hot-rolled alloy steel banding strip with silicon and manganese additions, width <300 mm, thickness <4.75 mm, not further worked. HTS 7226.91.80.00 applies to this 'other' category of hot-rolled alloy steel products.
Alloy Steel Hot-Rolled Shim Stock for Machinery
Thin hot-rolled alloy steel sheets used as shim stock in industrial machinery alignment, width less than 300 mm and under 4.75 mm thick. Classed in 7226.91.80.00 for hot-rolled, not further worked alloy steel of narrow width.
Chromium Alloy Hot-Rolled Steel for Gears
Hot-rolled flat alloy steel with chromium addition for gear blank production, <300 mm wide, thickness <4.75 mm, no further working. Meets HTS 7226.91.80.00 as other hot-rolled alloy steel not meeting special notes like tool or heat-resisting.
Nickel-Bearing Hot-Rolled Alloy Steel for Blades
Hot-rolled flat alloy steel with nickel for cutlery blade stock, <300 mm width, thickness <4.75 mm, not further worked. Falls under HTS 7226.91.80.00 for narrow, thin hot-rolled alloy steel excluding special types.
Vanadium Alloy Hot-Rolled Steel Sheet for Suspension
Thin hot-rolled alloy steel sheet with vanadium micro-alloying for vehicle suspension parts, width <300 mm, <4.75 mm thick. HTS 7226.91.80.00 for other hot-rolled, narrow alloy steel not further worked.