Hot-Rolled Silicon-Manganese Alloy Steel Banding
Narrow hot-rolled alloy steel banding strip with silicon and manganese additions, width <300 mm, thickness <4.75 mm, not further worked. HTS 7226.91.80.00 applies to this 'other' category of hot-rolled alloy steel products.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If high-strength steel per note (a)
Products meeting high-strength criteria (e.g., yield point 355 MPa for ≥3mm thick) classify under dedicated high-strength subheading.
If width of 600 mm or more
Wider flat-rolled alloy steel (>600mm but < width limit) falls under 7225 series for broader widths.
If manufactured into tubes or pipes
Post-import forming into tubes shifts classification to Chapter 73 tubes/pipes of alloy steel.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Include chemical composition report showing alloy elements; distinguishes from carbon steel under 7211
• Avoid bulk rust claims—no reductions allowed per Chapter 72 note on discoloration before entry
• Label entries clearly as 'not further worked'; inspections often check for coatings triggering reclass
Related Products under HTS 7226.91.80.00
Hot-Rolled Alloy Steel Strip for Automotive Springs
Hot-rolled flat-rolled alloy steel strip, less than 300 mm wide and under 4.75 mm thick, not further worked beyond hot-rolling. Classified under HTS 7226.91.80.00 due to its alloy steel composition, narrow width, and hot-rolled state without additional processing like cold-rolling or coating.
Narrow Hot-Rolled Alloy Steel for Tool Manufacturing
Hot-rolled alloy steel flat products, width under 300 mm and thickness below 4.75 mm, used in tool production. Fits HTS 7226.91.80.00 as 'other' hot-rolled alloy steel not further worked, distinguishing from high-strength or tool steel specifics in notes.
Alloy Steel Hot-Rolled Shim Stock for Machinery
Thin hot-rolled alloy steel sheets used as shim stock in industrial machinery alignment, width less than 300 mm and under 4.75 mm thick. Classed in 7226.91.80.00 for hot-rolled, not further worked alloy steel of narrow width.
Chromium Alloy Hot-Rolled Steel for Gears
Hot-rolled flat alloy steel with chromium addition for gear blank production, <300 mm wide, thickness <4.75 mm, no further working. Meets HTS 7226.91.80.00 as other hot-rolled alloy steel not meeting special notes like tool or heat-resisting.
Nickel-Bearing Hot-Rolled Alloy Steel for Blades
Hot-rolled flat alloy steel with nickel for cutlery blade stock, <300 mm width, thickness <4.75 mm, not further worked. Falls under HTS 7226.91.80.00 for narrow, thin hot-rolled alloy steel excluding special types.
Vanadium Alloy Hot-Rolled Steel Sheet for Suspension
Thin hot-rolled alloy steel sheet with vanadium micro-alloying for vehicle suspension parts, width <300 mm, <4.75 mm thick. HTS 7226.91.80.00 for other hot-rolled, narrow alloy steel not further worked.