Monel 400 Stainless Flat Wire 1.8mm x 0.7mm
Nickel-copper Monel 400 alloy classified as stainless steel flat wire, 1.8mm x 0.7mm. HTS 7223.00.50.00 for marine-grade flat wire in propeller shafts. Exceptional seawater corrosion resistance.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If predominantly nickel alloy
Nickel-based alloys exceeding steel definitions classified in Chapter 75.
If heat-resisting specifications
Certain high-temp alloys use specific alloy steel subheadings.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Verify nickel content certification; high nickel may prompt Chapter 75 review
• Document marine end-use to support wire vs bar distinction
• Ensure rectangular cross-section verified by customs gauge
Related Products under HTS 7223.00.50.00
AISI 304 Stainless Steel Flat Wire 1.5mm x 0.5mm
Flat-rolled stainless steel wire in rectangular cross-section, 1.5mm wide by 0.5mm thick, conforming to AISI 304 grade with 18% chromium and 8% nickel. Classified under HTS 7223.00.50.00 as flat wire of stainless steel, distinct from round wire or bars. Used primarily for weaving into fine mesh screens and filters.
316L Stainless Steel Flat Ribbon Wire 2mm x 0.8mm
Cold-drawn 316L stainless steel flat wire, 2mm width by 0.8mm thickness, low carbon variant for weldability. HTS 7223.00.50.00 applies to stainless steel flat wire used in medical device springs and surgical instruments. High corrosion resistance suits harsh environments.
AISI 430 Stainless Steel Flat Wire 3mm x 1mm
Ferritic AISI 430 stainless steel flat wire, 3mm wide by 1mm thick, with 16-18% chromium for magnetic applications. Falls under HTS 7223.00.50.00 as stainless flat wire for automotive trim and clips. Offers good formability and corrosion resistance in decorative uses.
17-4 PH Stainless Steel Flat Spring Wire 4mm x 0.6mm
Precipitation-hardening 17-4 PH stainless flat wire, 4mm x 0.6mm, for high-strength springs. HTS 7223.00.50.00 covers this stainless flat wire used in aerospace and valve components. Provides excellent tensile strength post heat treatment.
302 Stainless Steel Flat Weaving Wire 1mm x 0.3mm
AISI 302 spring-tempered stainless flat wire, ultra-thin 1mm x 0.3mm for precision weaving. Classified HTS 7223.00.50.00 as stainless flat wire essential for industrial filter mesh. High fatigue resistance for continuous flex applications.
Stainless Steel Flat Annealed Wire 2.5mm x 0.4mm
Soft annealed stainless steel flat wire 2.5mm x 0.4mm for easy forming in bindings and clips. HTS 7223.00.50.00 designation for stainless flat wire without hardening treatments. Ideal for post-forming fabrication processes.