316L Stainless Steel Flat Ribbon Wire 2mm x 0.8mm
Cold-drawn 316L stainless steel flat wire, 2mm width by 0.8mm thickness, low carbon variant for weldability. HTS 7223.00.50.00 applies to stainless steel flat wire used in medical device springs and surgical instruments. High corrosion resistance suits harsh environments.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If carbon steel rather than stainless
Carbon steel flat wire classified under heading 7222 for non-alloy/other steel wire.
If shaped for tube/pipe reinforcement
Wire deformed or shaped for specific end uses like concrete reinforcement shifts to tubes/pipes chapter.
If heat-treated or further worked
Surface-treated stainless flat-rolled products move to 'further worked' provisions in heading 7219.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Submit chemical analysis report verifying molybdenum content for 316L grade to confirm stainless steel status
• Avoid common pitfall of misdeclaring thickness; precise caliper measurements required at entry
• Check for any polishing or coating that triggers 'further worked' reclassification
Related Products under HTS 7223.00.50.00
AISI 304 Stainless Steel Flat Wire 1.5mm x 0.5mm
Flat-rolled stainless steel wire in rectangular cross-section, 1.5mm wide by 0.5mm thick, conforming to AISI 304 grade with 18% chromium and 8% nickel. Classified under HTS 7223.00.50.00 as flat wire of stainless steel, distinct from round wire or bars. Used primarily for weaving into fine mesh screens and filters.
AISI 430 Stainless Steel Flat Wire 3mm x 1mm
Ferritic AISI 430 stainless steel flat wire, 3mm wide by 1mm thick, with 16-18% chromium for magnetic applications. Falls under HTS 7223.00.50.00 as stainless flat wire for automotive trim and clips. Offers good formability and corrosion resistance in decorative uses.
17-4 PH Stainless Steel Flat Spring Wire 4mm x 0.6mm
Precipitation-hardening 17-4 PH stainless flat wire, 4mm x 0.6mm, for high-strength springs. HTS 7223.00.50.00 covers this stainless flat wire used in aerospace and valve components. Provides excellent tensile strength post heat treatment.
302 Stainless Steel Flat Weaving Wire 1mm x 0.3mm
AISI 302 spring-tempered stainless flat wire, ultra-thin 1mm x 0.3mm for precision weaving. Classified HTS 7223.00.50.00 as stainless flat wire essential for industrial filter mesh. High fatigue resistance for continuous flex applications.
Stainless Steel Flat Annealed Wire 2.5mm x 0.4mm
Soft annealed stainless steel flat wire 2.5mm x 0.4mm for easy forming in bindings and clips. HTS 7223.00.50.00 designation for stainless flat wire without hardening treatments. Ideal for post-forming fabrication processes.
Monel 400 Stainless Flat Wire 1.8mm x 0.7mm
Nickel-copper Monel 400 alloy classified as stainless steel flat wire, 1.8mm x 0.7mm. HTS 7223.00.50.00 for marine-grade flat wire in propeller shafts. Exceptional seawater corrosion resistance.