321 Stainless Steel Angle Bar 150x75x12mm Unequal
Hot-rolled unequal angle in stabilized 321 stainless steel, 150x75mm legs with 12mm thickness, max dimension 150mm >80mm. Classed under HTS 7222.40.30.25 as plain hot-rolled stainless angles for high-temperature exhaust systems.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If sold as part of a machinery set
Semi-finished products for specific machines classified by end-use in 7228, not general bars.
If pre-drilled for equipment mounting
Drilled/punched angles become 'other structures' in Chapter 73.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Document welding limitations if any, but confirm no post-roll punching/drilling occurred
• Reference AISI/UNS standards in entry docs for grade authentication
Related Products under HTS 7222.40.30.25
Hot-Rolled 316 Stainless Unequal Angle 140x70x10mm
316 stainless hot-rolled unequal angle for chemical plants, 140x70mm x 10mm, max 140mm.
Hot-Rolled 304L Stainless Equal Angle 100x100x12mm
Low-carbon 304L stainless hot-rolled equal angle, 100mm legs x 12mm thick, max cross-section 100mm. HTS 7222.40.30.25 applies to these weldable structural angles without advanced processing, common in food processing frames.
17-4 PH Stainless Steel Angle 110x110x10mm
Precipitation-hardening 17-4 PH stainless hot-rolled angle, 110mm square x 10mm, exceeding 80mm max dimension. Under HTS 7222.40.30.25 for hot-rolled stainless shapes in aerospace structural components.
409 Stainless Steel Hot-Rolled Angle 90x60x8mm
Automotive-grade 409 ferritic stainless unequal angle, hot-rolled 90x60mm x 8mm thick, max 90mm >80mm. HTS 7222.40.30.25 for exhaust system angles, not punched.
310 Stainless Steel Angle Section 120x120x15mm
High-temperature 310 stainless hot-rolled angle, 120mm equal x 15mm thick. Fits HTS 7222.40.30.25; not heat-resisting per notes (Cr content).
Hot-Rolled 304 Stainless Steel Angle Bar 100x100x10mm
A hot-rolled angle section made from 304 stainless steel with equal legs of 100mm and 10mm thickness, featuring a maximum cross-sectional dimension over 80mm. Classified under HTS 7222.40.30.25 as hot-rolled stainless steel angles, not drilled, punched, or further advanced beyond rolling. Used in structural framing for corrosion-resistant applications.