Hot-Rolled 304 Stainless Steel Angle Bar 100x100x10mm
A hot-rolled angle section made from 304 stainless steel with equal legs of 100mm and 10mm thickness, featuring a maximum cross-sectional dimension over 80mm. Classified under HTS 7222.40.30.25 as hot-rolled stainless steel angles, not drilled, punched, or further advanced beyond rolling. Used in structural framing for corrosion-resistant applications.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If made of non-stainless alloy steel
Non-stainless stainless steel angles fall under heading 72.19 for other alloy steel bars/sections, not Chapter 72 stainless steel.
If maximum cross-sectional dimension under 80mm
Smaller dimension angles are classified in the subheading for <80mm sections within the same hot-rolled stainless steel category.
If fabricated into structural assemblies or welded
Further worked or assembled steel structures move to Chapter 73 as fabricated metal products, not raw bars/rods.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Verify stainless steel grade certification (e.g
• AISI 304) and chemical composition to confirm Chapter 72 classification and avoid reclassification as alloy steel
• Ensure dimensions are documented with mill test certificates showing maximum cross-section ≥80mm and hot-rolled condition without drilling/punching
Related Products under HTS 7222.40.30.25
Hot-Rolled 316 Stainless Unequal Angle 140x70x10mm
316 stainless hot-rolled unequal angle for chemical plants, 140x70mm x 10mm, max 140mm.
Hot-Rolled 304L Stainless Equal Angle 100x100x12mm
Low-carbon 304L stainless hot-rolled equal angle, 100mm legs x 12mm thick, max cross-section 100mm. HTS 7222.40.30.25 applies to these weldable structural angles without advanced processing, common in food processing frames.
17-4 PH Stainless Steel Angle 110x110x10mm
Precipitation-hardening 17-4 PH stainless hot-rolled angle, 110mm square x 10mm, exceeding 80mm max dimension. Under HTS 7222.40.30.25 for hot-rolled stainless shapes in aerospace structural components.
409 Stainless Steel Hot-Rolled Angle 90x60x8mm
Automotive-grade 409 ferritic stainless unequal angle, hot-rolled 90x60mm x 8mm thick, max 90mm >80mm. HTS 7222.40.30.25 for exhaust system angles, not punched.
310 Stainless Steel Angle Section 120x120x15mm
High-temperature 310 stainless hot-rolled angle, 120mm equal x 15mm thick. Fits HTS 7222.40.30.25; not heat-resisting per notes (Cr content).
316L Stainless Steel Hot-Rolled Angle 125x125x12mm
Hot-rolled unequal leg angle from marine-grade 316L stainless steel, 125mm leg with 12mm thickness, max cross-section exceeding 80mm. Fits HTS 7222.40.30.25 for hot-rolled stainless angles not advanced beyond rolling. Ideal for harsh environments like coastal construction.