Cold-Finished 316 Stainless Steel Round Bar 25mm
A cold-finished round bar made from 316 stainless steel alloy, containing approximately 10-14% nickel by weight, with a circular cross-section of 25 mm diameter (between 18 mm and 152.4 mm). Classified under HTS 7222.20.00.64 as a not further worked stainless steel bar with 8-24% nickel content, cold-formed or cold-finished. Used in marine and chemical processing equipment.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If containing less than 8% nickel
Lower nickel content stainless steel bars fall under different subheading in 7222.11 for nickel-free or low-nickel alloys.
If further worked with polishing or coating
Any surface treatment beyond cold-finishing (per chapter note on 'further worked') shifts to 7222.30 headings.
If angular or non-circular cross-section
Non-circular shapes like hex or square are classified in 7222.40 rather than circular cross-section subheadings.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide mill test certificates verifying nickel content between 8-24% by weight; declare exact diameter to confirm 18-152.4mm range; watch for reclassification if any surface treatments like polishing qualify as 'further worked'
Related Products under HTS 7222.20.00.64
17-4 PH Stainless Steel Cold-Drawn Rod 40mm
Cold-drawn precipitation hardening 17-4 PH stainless steel rod with 15% nickel content, circular cross-section of 40 mm diameter. Fits HTS 7222.20.00.64 for cold-finished stainless bars with 8-24% nickel, not further worked. Ideal for aerospace structural components requiring high strength.
Nitronic 50 Stainless Steel Cold-Formed Bar 80mm
Cold-formed Nitronic 50 (XM-19) stainless steel bar containing 12% nickel, with 80 mm circular cross-section (18-152.4 mm range). HTS 7222.20.00.64 applies to these cold-finished, nickel-bearing (8-24%) stainless bars not further worked. Used in high-stress valve stems and pump shafts.
321 Stainless Steel Cold-Finished Round Rod 100mm
Cold-finished 321 stabilized stainless steel rod with 9-12% nickel content and 100 mm diameter circular cross-section. Classified in HTS 7222.20.00.64 for cold-formed stainless bars (8-<24% nickel, 18-152.4 mm dimension), not further worked. Common in exhaust systems and welded fabrications.
310 Stainless Steel Cold-Drawn Shaft Blank 60mm
Cold-drawn 310 high-temperature stainless steel bar stock with 19-22% nickel, 60 mm round cross-section. Meets HTS 7222.20.00.64 criteria for cold-finished stainless bars containing 8-24% nickel, max dimension 18-152.4 mm, not further worked. Applied in furnace parts and heat exchangers.