Containing 8 percent or more but less than 24 percent by weight of nickel
Other bars and rods of stainless steel; angles, shapes and sections of stainless steel: > Bars and rods, not further worked than cold-formed or cold-finished > Other: > Of a circular cross-section: > With a maximum circular cross-sectional dimension of 18 mm or more and less than 152.4 mm: > Containing 8 percent or more but less than 24 percent by weight of nickel
Duty Rate (from China)
Except for products described in headings 9903.03.02–9903.03.11, articles the product of any country, as provided for in subdivision (aa) of U.S. note 2 to this subchapter
Effective with respect to entries on or after September 27, 2024, articles the product of China, as provided for in subdivision (b) of U.S. note 31 to this subchapter
Products classified under HTS 7222.20.00.64
Cold-Finished 316 Stainless Steel Round Bar 25mm
A cold-finished round bar made from 316 stainless steel alloy, containing approximately 10-14% nickel by weight, with a circular cross-section of 25 mm diameter (between 18 mm and 152.4 mm). Classified under HTS 7222.20.00.64 as a not further worked stainless steel bar with 8-24% nickel content, cold-formed or cold-finished. Used in marine and chemical processing equipment.
17-4 PH Stainless Steel Cold-Drawn Rod 40mm
Cold-drawn precipitation hardening 17-4 PH stainless steel rod with 15% nickel content, circular cross-section of 40 mm diameter. Fits HTS 7222.20.00.64 for cold-finished stainless bars with 8-24% nickel, not further worked. Ideal for aerospace structural components requiring high strength.
Nitronic 50 Stainless Steel Cold-Formed Bar 80mm
Cold-formed Nitronic 50 (XM-19) stainless steel bar containing 12% nickel, with 80 mm circular cross-section (18-152.4 mm range). HTS 7222.20.00.64 applies to these cold-finished, nickel-bearing (8-24%) stainless bars not further worked. Used in high-stress valve stems and pump shafts.
321 Stainless Steel Cold-Finished Round Rod 100mm
Cold-finished 321 stabilized stainless steel rod with 9-12% nickel content and 100 mm diameter circular cross-section. Classified in HTS 7222.20.00.64 for cold-formed stainless bars (8-<24% nickel, 18-152.4 mm dimension), not further worked. Common in exhaust systems and welded fabrications.
310 Stainless Steel Cold-Drawn Shaft Blank 60mm
Cold-drawn 310 high-temperature stainless steel bar stock with 19-22% nickel, 60 mm round cross-section. Meets HTS 7222.20.00.64 criteria for cold-finished stainless bars containing 8-24% nickel, max dimension 18-152.4 mm, not further worked. Applied in furnace parts and heat exchangers.