Cold-Rolled 301 Stainless Steel Shaft Blank 15mm
15 mm diameter cold-rolled 301 stainless steel bar with under 8% nickel, used as shaft blanks in machinery. HTS 7222.20.0041 covers these small, cold-finished circular stainless rods. Known for high strength and ductility in spring applications.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If nickel content reaches 8% or higher
Nickel percentage threshold splits 7222.20 subheadings for cold-finished circular stainless bars.
If semi-finished or hot-rolled hollow drill bars
Hollow structure or drill-specific design moves to 7228 for specialized semi-finished steel products.
If pre-machined into semi-finished shafts
Machining constitutes further working or part classification under Chapter 73.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Document cold-rolling process only, no annealing/polishing; test for nickel via spectrometry if challenged
• Declare quantity by weight and length for accurate duty calculation
Related Products under HTS 7222.20.00.41
443 Stainless Cold Bar 12.8mm Circular
Automotive 443 stainless cold bar, 12.8 mm dia., <8% Ni for trim. HTS 7222.20.0041 stainless rod. ESR refined.
Cold-Drawn 304 Stainless Tie Bar 16.9mm
16.9 mm 304 stainless tie bar stock, cold-drawn <8% Ni for concrete forms. HTS 7222.20.0041. General corrosion resistance.
439LF Stainless Steel Cold Rod 17mm Diameter
Low-ferrite 439LF stainless cold rod, 17 mm round, <8% Ni for exhaust manifolds. HTS 7222.20.0041 for cold-finished stainless bars this size. Optimized weldability.
301 Full Hard Cold-Rolled Bar 10.5mm
Full hard condition 301 stainless bar, 10.5 mm dia., cold-rolled <8% Ni for springs. HTS 7222.20.0041 cold-finished stainless rod. High tensile strength.
Cold-Finished 304 Stainless Steel Round Bar 10mm
A cold-finished round bar of 304 stainless steel with a 10 mm diameter and less than 8% nickel content, not further worked beyond cold-forming. This falls under HTS 7222.20.0041 due to its circular cross-section under 18 mm, stainless steel composition, and minimal nickel. Commonly used in precision mechanical applications requiring corrosion resistance.
420 Stainless Cold-Finished Dowel Rod 14mm
14 mm 420 martensitic stainless dowel rod, cold-finished <8% Ni for hardened pins. HTS 7222.20.0041 small stainless bar. Corrosion resistant when hardened.