Cold-Formed 430 Stainless Steel Bar 14.5mm Round
A 14.5 mm diameter round bar of 430 stainless steel, cold-formed with less than 8% nickel, used in automotive trim and hardware. HTS 7222.20.0041 applies to these small-section, cold-finished stainless bars without additional processing. Offers good formability and moderate corrosion resistance.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If of circular cross-section but from non-stainless steel
Non-stainless bars and rods, cold-formed, are under 7213, distinguished by lack of minimum chromium for stainless steel definition.
If of non-circular cross-section like square or hexagonal
Shape determines primary subdivision; non-circular cold-finished bars go to 7222.20.0070 regardless of size.
If deformed for concrete reinforcement use
Per Chapter 72 note (c), bars with ribs/grooves for reinforcing concrete are classified in 7304 as specialized products.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Submit mill certificates for alloy grade 430 confirming stainless properties and low nickel; measure cross-section accurately to stay under 18 mm limit
• Avoid bundling with further-worked items to prevent lot reclassification
Related Products under HTS 7222.20.00.41
443 Stainless Cold Bar 12.8mm Circular
Automotive 443 stainless cold bar, 12.8 mm dia., <8% Ni for trim. HTS 7222.20.0041 stainless rod. ESR refined.
Cold-Drawn 304 Stainless Tie Bar 16.9mm
16.9 mm 304 stainless tie bar stock, cold-drawn <8% Ni for concrete forms. HTS 7222.20.0041. General corrosion resistance.
439LF Stainless Steel Cold Rod 17mm Diameter
Low-ferrite 439LF stainless cold rod, 17 mm round, <8% Ni for exhaust manifolds. HTS 7222.20.0041 for cold-finished stainless bars this size. Optimized weldability.
301 Full Hard Cold-Rolled Bar 10.5mm
Full hard condition 301 stainless bar, 10.5 mm dia., cold-rolled <8% Ni for springs. HTS 7222.20.0041 cold-finished stainless rod. High tensile strength.
Cold-Finished 304 Stainless Steel Round Bar 10mm
A cold-finished round bar of 304 stainless steel with a 10 mm diameter and less than 8% nickel content, not further worked beyond cold-forming. This falls under HTS 7222.20.0041 due to its circular cross-section under 18 mm, stainless steel composition, and minimal nickel. Commonly used in precision mechanical applications requiring corrosion resistance.
420 Stainless Cold-Finished Dowel Rod 14mm
14 mm 420 martensitic stainless dowel rod, cold-finished <8% Ni for hardened pins. HTS 7222.20.0041 small stainless bar. Corrosion resistant when hardened.